ClearRF WRE2710-S Operators Manual And Installation Manual

WRE2 2710‐S O Operator'
M2M –Machi ne to Ma
Overvi iew
The WRE2 2710 Wireless s Network Ra
bidirectio nal RF amplif fier for the en
bands. Th he amplifier h as an automa
the gain a and the outpu ut power if a s
tethered (direct conne ect) unit withi
coverage areas. The in put power re
(negative ground). This s M2M kit inc
AC power r.
Passive e Bypass Technolo
The WRE2 2710 amplifie er is equipped
amplifier to passively b bypass itself a
needed, d during loss of power or wh
Passive By ypass techno logy is useful
poor signa al areas. The amplifier will
potential for network d disrupting no
technolog gy is also extr emely useful
antenna m must always b be maintained
MAN‐544 46‐001 Rev 6
's Manu al and In
achine
ange Extende r is a high per
ntire North Am merican 850 M
atic gain and oscillation co
signal anoma ly occurs. Thi
in a cellular sy ystem, for ma
equirements f for the amplif
cludes an AC power adapte
ogy – Pate ent Pendin
d with ClearRF F's Passive By
and become m merely a pass
hen a fault is d detected.
in applicatio ns where the
l bypass itself f when close t
oise power ca used by too m
in fire and se ecurity system
d, even with loss of power
nstallatio on Guide
rformance, m microprocesso
MHz cellular and 1900 MH
ontrol system that will auto
is amplifier is s designed to
aximum perfo ormance in w
fier are positi ive 8.0 to 36.0
er for use wit th typical hou
ng
ypass technol logy. This feat
s through cab ble when amp
e amplifier is m mobile, movi
to cell towers s, completely
much amplific cation near a
m installation s where a con
r.
™
e:
or controlled,
Hz PCS freque ency
omatically ad just
operate as a
weak signal
0 volts DC
usehold 120 v volt
ture allows th he
plification is n not
ng in and out t of
y eliminating a any
cell tower. T he
nnection with h the
1