Advertisement
2601-06 6-Gang Charger, UL/CE - Fully Assembled
Charger LED
2601-06B 6-Gang Charger Bracket - Requires one to six 2600-01 Chargers
Assemble from 1 to 6 MAXAIR Systems 2600-01 Chargers to the Gang Charger Bracket
D. Hold the bracket securely in one hand
with the charger clips towards the top.
Begin sliding a 2600-01 Charger into an
empty charger clip, with battery connec-
tion cord towards the top.
G. Connect one of the six
extensions of the Charger Power
Cord securely to the Power Cord
Connector on one Charger.
A. The 6-Gang Charger ships fully
assembled with six 2600-01
chargers.
Screws for mounting on a cart,
and anchors for mounting on a
wall are included as options.
Charger
Clip
E. Continue pushing
Charger down into
Charger Clip towards
the Clip Seat.
H. Repeat steps D.-G. for
each additional Charger
to be installed on the
Charger Bracket.
When fully assembled and mounted, follow steps A.- C. for use (above).
C. Connect from 1 to 6 MAXAIR Li-Ion 2000-36/2000-
30 batteries to the charger. If the battery needs
charging the Charger LED will turn red. It will turn
green again when the battery is ready for use. If it
remains green, the battery is ready for use.
Clip
Seat
I.
B. When ready to charge,
connect the Gang
Charger power cord to
an appropriate mains
supply.
Mains supply
Gang Charger
Power Cord
F. Charger is fully assembled on
the Bracket when it is fully
against the Clip Seat.
NOTE: Chargers may be in-
serted as shown or opposite,
top to bottom.
With the Charger Bracket fully
assembled with the desired number
of chargers (one to six) proceed to
mount the charger in the desired
location. Screws for mounting on a
cart, and anchors for mounting on a
wall are included as options.
P/N 01423158 REV A
Advertisement
