Related Manuals for Hidrotermal CrayFish
Summary of Contents for Hidrotermal CrayFish
- Page 1 ® CrayFish Automated Cleaner Robot USER MANUAL Note: Subject to update by manufacturer without notice in advance...
- Page 2 Important Precautions 1. In order to prevent severe damage to the cleaner, never power on the unit when it is outside of the swimming pool. 2. The power cord must be connected to an appropriate earthed socket. 3. Do not operate the cleaner when people are in the pool. 4.
- Page 3 17. It may cause minor pollution in case of the leaking from the oil seal. When put the cleaner into the water please make sure hold the top handle make sure to empty the trapped air inside, then the cleaner can immerse into the pool floor. When pulling cleaner out of water suspend the cleaner above water for about 10-15 seconds to empty the water inside.
-
Page 4: Table Of Contents
Content Introduction··························································································P 4 Safety···································································································P 4 III. Specifications························································································P 5 IV. Operation······························································································P 6 V. Instruction of installing the caddy····························································P14 VI. Packing List···························································································P15 VII. Warranty ····· ·························································································P16... -
Page 5: Introduction
I. Introduction ® The Hidrotermal crayfish automated cleaner robot is a new type of highly efficient and energy-saving swimming pool cleaning system. Through its advanced computer controlled program, it can clean the pool walls and bottom automatically. At the same time, it filters the pool water and gets rid of suspended particles without replace the pool water. -
Page 6: Specifications
III. Specifications Rated input voltage: 220VAC (230VAC)/ 110VAC (120VAC) Frequency: 50Hz/60Hz Output voltage: DC24V Power: 200W Remote control frequency: 433M Cable length: 20/30/40M Roller length: 465mm Roller Style: PVC Roller, PVC+ Sponge Roller Max cleaning area: Appr. 270 ㎡ 10. Flow rate: 20m³/h 11. -
Page 7: Operation
IV. Operation 4.1 Panel Fig 4-1 SIGN INDICATE FUNCTION Press this button machine will be switched on. Press this button twice machine will ON/ OFF Switch on or Switch off work under selected mode. Press this button third time machine will be switched off. - Page 8 Choose different mode for different Mode options purpose. “ALL” mode is let machine clean swimming pool floor wall and water line together.(once wall then once floor) “WALL” mode is let machine clean swimming pool wall only. MODE “FLOOR” mode is let machine clean swimming pool floor only.
- Page 9 Different working Working duration option duration for different purpose. TIME 1H 2H 3H indicate different working duration Indicate the machine status Two or three indicators on Machine stopped 1H flash slowly Machine running for 1 hour 2H flash slowly Machine running for 2 hour 3Hflash slowly Machine running for 3 hour ALL light on...
- Page 10 4.2 Diagnose: INDICATOR MEANING SUGGESTION Put machine back into 1Hflash quickly with buzz. Machine out of water water or wait until machine restart automatically All lights flash quickly with Control box over Stop machine contact after buzz load sale service person 1H+2H+3H flash quick with Stop machine contact after Seal box leaking...
-
Page 11: Remote Control
4.3 Remote control Fig4-3 remote control SIGN INDICATE FUNCTION ANTENNA Signal reception Indicator light Working Press this button machine will working automatically automatically ▶ Right turn Keep press this button machine will turn right STOP Stop working Press this button machine will stop working Press this button machine will stop walking ▲... - Page 12 4.4 Clean the filter tray Lift the tray handle up (Fig:4-5） Take out the filter tray（Fig4-6） Lift handle up Fig4-5 Fig4-6 Slide the clip to open the tray（Fig 4-7） Take the slides off（Fig4-8） open open Fig4-7 Fig4-8 Clean the tray（Fig4-9；Fig4-10） Fig4-9 Fig4-10...
- Page 13 4.5 Put the filter tray back Machine have a slide way to lead filter tray back into the cleaner, and clip the handle in position perfectly (Fig 4-11、4-12、4-13）. Fig4-11 Fig4-12 Fig4-13...
-
Page 14: Instruction Of Installing The Caddy
Ⅴ.Instruction of installing the caddy 1. Open the package for assembling 2. Put the Connection part onto the plate 3. Insert the wheel axle， 4. Assemble the protecting cover and axle cover 5. Assemble wheel 6. Put on the nut 7. -
Page 15: Packing List
Ⅵ.Packing list Quantity Item Name Model Note (pc) Cleaner In Carton Power supply unit In Carton Manual and certificates, etc. Big Plastic Bag Filter bag Big Plastic Bag Cleaner Safety rope Big Plastic Bag Battery Mini Plastic Bag Antenna Mini Plastic Bag Remote control Mini Plastic Bag Top handle... - Page 16 Foam installation Attention: This foam is an extra assistant device which uses only for very specific situation: in case the robot in water is too weight to climb wall. if your robot is in good performance, please ignore this instruction. Solution 1: Dismantle the top cover and stick two foams on its reverse surface (see picture 1), make sure the two foams are on the diagonal of the middle part of top cover.
-
Page 17: Warranty
Ⅶ. Warranty This product has passed all quality control and safety tests, conducted by the technical department of the factory. Warranty information: 1. Warranty period is 2 years from the date of delivery and is settled in accordance with the terms established by Directive 1999/44/EC of 25 of May regarding guarantees on the sale of consumer goods as well as the local law in the Country of Purchase within the European...
Need help?
Do you have a question about the CrayFish and is the answer not in the manual?
Questions and answers