Hearth and Home Technologies IntelliFire IFT-RC150 User Manual

Introduction
The IFT-RC150 is a wall-mounted wireless wall switch
that is designed to operate Hearth & Home Technologies
appliances equipped
Technology. It can be used to control the ON/OFF and
cold-climate function of your appliance. This user guide
serves as a quick reference to the wall switch operation.
Operation
Flame ON/OFF
• To turn the flame ON, press the top of the rocker switch.
• To turn the flame OFF, press the bottom of the rocker
switch.
The appliance has a safety feature that automatically
shuts down the appliance after 9 hours of continuous
operation.
Cold Climate
This function turns on a continuous pilot and keeps the air
inside the appliance warm while not in use. It is a useful
feature in cold weather to minimize condensation on the
appliance glass.
• To turn the cold climate mode ON/OFF, press the small
momentary push button below the rocker switch.
Note: This feature is disabled when a Power Vent is
installed on the appliance.
LED Indicator
• The LED indicator is located above the rocker switch. It
blinks every time it transmits a command.
• The LED also functions as a low battery indicator.
Replace batteries if the red LED blinks once every 3
seconds continuously for longer than 5 minutes.
IntelliFire™ Touch Wireless Wall Switch
with the IntelliFire™
Hearth & Home Technologies • RC150 User Guide • 2326-981 Rev. B • 10/16
IFT-RC150
User Guide
RED LED
Touch
Figure 1. RC150 Functions
Power Outage
In the event of a power outage, the wall switch can
continue to operate the appliance if batteries are installed
in the appliance's battery backup system. Refer to the
appliance owner's manual for operation during a power
outage.
Note: Batteries should only be used as an appliance power
source in the event of a power outage. Batteries
should not be used as a primary long-term power
source.
COLD CLIMATE ON/OFF
FLAME ON
FLAME OFF
1