TAC 461.110M Manual

ForceCheck Wired and Wireless Display Manual
Overview
The display is designed for use in conjunction with
chuck and drawbar force sensors. Two versions are
available: wired and wireless (depending on the type
of sensor used).
Getting Started
Wireless: turn on the sensor.
Wired: connect the sensor to the display using the
supplied cable.
Press display's On/Off button. The unit will briefly
display the calibration due date for the sensor.
From this point, follow instructions for the particular
sensor in use.
When finished, Press On/Off to power down the
display. For wireless sensors, the sensor must be
powered down separately.
Wireless: The display can only communicate with
one sensor at a time. The display will connect to
the first sensor detected. To switch sensors, simply
turn off the first sensor and turn on the second. The
display will automatically connect to the second
sensor.
Zeroing the Display
The display will automatically zero on powerup. If
needed, the display can be re-zeroed at any time by
pressing the Zero button.
When peak force display is enabled, pressing the
Zero button will also reset the stored peak value.
Battery Replacement
The display uses a standard 9V battery. To replace
the battery, open the compartment on the back side.
A rechargeable battery can be used.
Calibration
Unlike our force sensors, the display does not
require calibration. However, firmware updates will
be available from time to time.
Specifications
Weight: 176 grams / 6.2 oz
Dimensions: 130x65x25 mm / 5.1x2.6x1.0 in
Operating Temperature: 10-32˚ C / 50-90˚ F
Battery: Standard 9V
Environmental Protection: While the display has
basic protection from dust, etc., the unit should be
kept clean and dry to prevent damage to internal
components.
Wireless Only:
Transmit/Receive Frequency: 2402-2480 MHz
Transmit/Receive Range: 20 m / 66 ft
Useful Conversion Factors
1 kN = 1,000 Newton (N)
1 N = 0.2248 pound-force (lbf)
1 lbf = 4.448 Newton (N)
1 N = 0.102 kilogram-force (kgf)
1 N = 0.102 kilopond (kp)
Continued on next page...
109 North Main Street | Rockford, IL 61101 USA
Tel. 815 962-5600 | Fax 815 962-4600
461.110M
14-0707 / Page 1 of 2
Uncontrolled Document
www.tac.us | info@tac.us