Powerplay PPBB-SP Instructions For Use Manual

1. Remove optional gel pack from inside of wrap and place in
freezer for a minimum of 1 hour. Then remove gel from freezer
and re-attach to the inside of the wrap. Make sure to keep a
protective thin cloth barrier between the skin and gel pack.
NOTE: Each time the gel pack thaws, refreeze for 1 hour.
2. Hold the wrap around waist, centering the back panel over
spine. Make sure the tubing is coming out of the top of the
wrap and outside of the belted area. (See back side for sizing
instructions.)
3. Wrap the left side of belt to the front, positioning the front
panel center on abdomen. Then wrap the right side on top of
the left panel to close and fasten in front.
Removable
Gel Pack
For questions about this product, call 855-PWR-PLAY (855-797-7529)
WWW.POWERPLAY.US
V1 07.16.15
PowerPlay

INSTRUCTIONS FOR USE

PPBB-SP
PRODUCT #:
1
Protective
Barrier
4
Power
Lanyard
Pulley
Cold & Compression Back Wrap
®
4. Pull the lanyard pulley out and away from the back panel
to desired compression and support. Fasten the pulley
securely on Velcro band. Adjust tension for sitting or
standing, experimenting to meet your needs. (See back
side for lanyard pulley shortening instructions.)
5. Connect the hose to a port on the PowerPlay pump. Press
the Power button to turn on the unit.
6. Press the Pressure Set button associated with that port
until the desired pressure (50 mmHg, 55 mmHg, 60
mmHg, 65 mmHg, 70mmHg) appears on the display.
NOTE: Pressure cannot be altered during an inflation
cycle.
Port
2
5
Select Port
3
6