Rockford Fosgate punch 40X2 Operating & Installation page 13

Punch series 2-channel amplifiers
Table of Contents

Advertisement

Punch 40x
, 60x
2
Trim the power cable to within 18" of the battery and install the
protective rubber boot, which is packed with the fuseholder, over
the end of the wire. Strip 3/8" of insulation from the wire and insert
into the end of the fuseholder, then crimp it in place. Slide the
rubber boot into place to cover the connection. Use the section of
cable that was trimmed earlier and connect it to the other end of
the fuseholder.
Punch 200x
2
Mount the fuseholder within 18" of the battery using two (2) #8
screws. Disassemble the fuseholder. You should have 2 black
plastic end caps, 2 gold-plated fuse clips, a plastic spacer and the
fuseholder body. Trim the amplifier power cable to reach the
fuseholder and strip the wire 3/8". Slide one of the end caps over
the wire (narrow end first) and insert the wire into one of the fuse
clips. Tighten the set screw. Screw the black end cap to the
fuseholder body to secure the cable. Use the section of cable that
was trimmed earlier and connect it to the other end of the
fuseholder. Install the plastic spacer in the fuseholder and attach
the cable to the fuseholder body.
NOTE: The B+ cable MUST be fused 18" or less from the vehicle's
battery. Install the fuseholder under the hood and prepare the
cable ends as stated above. Connections should be water tight.
4. Strip 3/8" from the battery end of the power cable and crimp a large
ring terminal to the cable. Use the ring terminal to connect to the
battery positive terminal. Do not install the fuse at this time.
5. Prepare a length of cable to be used for the ground connection.
Strip 5/8" of insulation from the end of the cable as described
previously and connect to the appropriate terminal of the ampli-
fier. Prepare the chassis ground by scraping any paint from the
metal surface and thoroughly clean the area of all dirt and grease.
Strip the other end of the wire and attach a ring connector. Fasten
the cable to the chassis using a non-anodized screw and a star
washer.
, 100x
2
2
– 10 –

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Punch 60x2Punch 100x2Punch 200x2Punch 40x2

Table of Contents