Speakers; Bridged/Mono Configuration; Passive Crossover Impedance - Rockford Fosgate 4-CHANNEL AMPLIFIER Owner's Manual

Speakers

Bridged/Mono
Configuration
Passive
Crossover
Impedance
Punch 4-Channel amplifiers are rated for safe operation
into loads of 2 , or greater in stereo mode or 4
bridged/mono configurations. The primary loads on any
amplifier come from directly connected speakers without
using capacitors. The measured resistance for each side
should not be less than 2 stereo or 4 bridged/mono.
The Punch 4-Channel amplifiers are capable of bridged/
mono configurations.
This configuration enables you to:
• Run amplifier as a separate 2 channel subwoofer or
satellite amplifier.
• Create a high power stereo system
• Run 2 channels with a bridged mono woofer and the
other 2 as a high-frequency stereo amp, etc.
Note: Both Punch 4-Channel amplifiers allow the
above 3 configurations all in one.
For more information refer to the wiring diagrams begin-
ning on page 18.
Note: To bridge the amplifier use the L+ and R–
speaker connectors.
Caution! Punch 4-Channel amplifiers are not recom-
mended for impedance loads below 2 stereo or 4
bridged/mono.
Be sure to observe proper speaker terminal polarity
throughout the system. It is critical for the Punch 4-
Channel to use the correct negative terminals for
right and left channels, since the RIGHT NEGATIVE
(–) terminal is the "hot" terminal for the right speaker.
DO NOT chassis ground any of the speaker leads as
unstable operation may result.
A passive crossover is a circuit that employs capacitors
and/or coils and is placed on speaker leads between the
amplifier and speaker to delegate frequencies in the
speaker's optimum performance range.
14
in