Troubleshooting; Warranty - Rockford Fosgate IBeam IB-200 Installation And Operation Manual

SYMPTOM
Weak bass (vibrations)
No sound from unit
Sound too high pitched
Undesired vibrations
Stops operating
The IBeam tactile transducer has a warranty of 1 Year. This warranty covers only the original
purchaser of Rockford product purchased from an Authorized Rockford Fosgate Dealer in the
United States. In order to receive service, the purchaser must provide Rockford with a copy of
the receipt stating the customer name, dealer name, product purchased and date of purchase.
Products found to be defective during the warranty period will be repaired or replaced (with a
product deemed to be equivalent) at Rockford's discretion.
What is Not Covered
1. Damage caused by accident, abuse, improper operations, water, theft, shipping
2. Any cost or expense related to the removal or reinstallation of product
3. Service performed by anyone other than Rockford or an Authorized Rockford Fosgate
Service Center
4. Any product which has had the serial number defaced, altered, or removed
5. Subsequent damage to other components
Limit on Implied Warranties
Any implied warranties including warranties of fitness for use and merchantability are limited
in duration to the period of the express warranty set forth above. Some states do not allow
limitations on the length of an implied warranty, so this limitation may not apply. No person
is authorized to assume for Rockford Fosgate any other liability in connection with the sale
of the product.
How to Obtain Service
Contact the Authorized Rockford Fosgate Dealer you purchased this product from.
If you need further assistance, call 1-800-669-9899 for Rockford Customer Service.

Troubleshooting

CAUSE
low settings
little bass in source
wires disconnected
amp off
no line level signal to amp
internal damage to unit
crossover frequency to high
no crossover
improper mounting
non-home theater seating used
poor seat construction
overload protection activated
Limited Warranty
SOLUTION
increase the amp gain and/or
raise source input level
many older recordings
lack much deep bass sound
check speaker level wiring
turn on amp
check line level wiring and signal
contact customer service
lower crossover
set point to 150Hz
adjust lower as desired
install in-line filter
review mounting instructions
and correct the mounting issues
purchase dedicated seating
isolate noise and apply sound
damping material to seat
allow fuse to reset (3-5min)
lower amp settings