Advertisement
4. ASSEMBLY
4.1.
Fit handle see Step 1
4.1.1.
Attach handle with 6mm x 12mm hex bolts, spring and flat washers.
4.2.
Fit casters See Step 2
WARNING! Two or more people are required to lay down or stand up the cabinet. DO NOT stand in front or behind and lock drawers
‰
whilst turning over.
4.2.1.
Carefully lay the cabinet upside down with a soft mat underneath for protection.
4.2.2.
Fit the two swivel/braked castors, on the handle side using 10mm x 25mm bolts, through each castor and into the bottom of the
cabinet. Tighten securely.
4.2.3.
Repeat for the two rigid casters on the other side.
Step 1
4.3.
Drawers See Step 3
4.3.1.
New drawers slides may be stiff and difficult to open at first. A gentle outward pull should release the safety catch that prevents the
drawer from opening whilst the cabinet is being moved.
4.3.2.
Remove drawers from their slides as below (pull left slide tab down and pull right side slide tab up).
4.4.
Fit uprights See Step 4 & Step 5
4.4.1.
Fit the two uprights to the cabinet with four 6mm x 14mm hex bolts
to each.
4.4.2.
Insert the upper section of the uprights into the lower one (Step 5).
Step 4
© Jack Sealey Limited
Step 3
Original Language Version
Step 2
Step 5
AP5520SS | Issue 1 - 10/05/16
Advertisement
