Adtec RD-30 Quick Start Manual

RD-30
MultiCODEC 4:2:0 Receiver / Decoder
Thank you for your purchase of the Adtec RD-30
4:2:0 Receiver/Decoder. The RD-30 is sold with
optional demodulator hardware and software
licenses. Please note that some configurations
may not be available in the front panel if the
licensed feature is not installed.
Quick View Status
The main status menu contains:
- Bitrate of incoming stream
- Current active Input
- IP Address of management port
- Current decoded service name
Unit Name
Bitrate: 19.400 Mbps
Input: MPEG/IP 2 Stream 1
IP: 192.168.10.48
Service: Adtec HDTV
LED Status
Input
Off - Decoder does not have valid input
On - Decoder has valid input
Error / Alarm
Off - No errors detected
On - Active errors
Unit ID
Off - UID is disabled
On - UID configuration is enabled
Adtec Digital US Sales +1-615-256-6619 International Sales +1-904-394-0389 www.adtecdigital.com
Conditional
Decoding
Inputs
Access
Input Select DVB-CI Service Select
Switch to Backup
BISS Video
ASI Rx Ancillary Status
IP Rx (MPEG/IP) Audio 1
RF Rx (DVB-S2 1)
Audio 2
Audio 3
Audio 4
SCTE35
MultiCODEC 420 Receiver / Decoder
RD - 30
Bitrate: 21.694 Mbps
Input: ASI
IP: 192.168.10.48
Quick Start Guide
Baseband
Processing TS Outputs
Outputs
Video SDI
ASI Output
IP Output
Composite
Audio
SCTE35 Analog
SCTE104 Digital (AES)
Genlock
Source ID
Front Panel Navigation:
Use the Enter
Button to enter
menus, enter edit
mode, and confirm
configuration
changes.
Use arrows for
navigation in
sub-menus and edit
mode.
Use Back to move to
top level menus or
to cancel configura-
tion editing.
BACK
RD-30
ENTER
INPUT
Admin Active Errors
Network
Error List
Mpeg/IP Network
Time
About
Syslog
Voltage Levels
Unit Temp.
Pro le
Lock Front Panel
Reset
UID
2014 Adtec Digital