Fox MIG-200D User Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

User Manual

MIG-200D

Table of Contents

Need help?

Do you have a question about the MIG-200D and is the answer not in the manual?

Questions and answers

Summary of Contents for Fox MIG-200D

Page 1 User Manual MIG-200D...
Page 2: Safety Warning
SAFETY WARNING On the process of welding or cutting, there will be possibility of injury, so please take protection into consideration during operation. For more details please review the Operator Safety Guide, which complies with the preventive requirements of the manufacturer.
Page 3: Machine Description
Creep age-protecting switch should be added when using the machine！！！ MACHINE DESCRIPTION The MIG-200D portable MIG welder, uses ac single phase 230V, 50HZ with time delayed fuse or circuit breaker. The key features are as below: ● Advanced IGBT Inverter technology.
Page 4: Technical Parameters Table
TECHNICAL PARAMETERS TABLE Model MIG-200D Input Voltage 230V Input Power 6.8KVA No-load voltage Current Range MIG: 30-200A MMA:20-170A Duty Cycle Welding Wire MIG: 0.6-1.0 MMA:1.6-4.0 Efficiency Protection Level Weight 17kg Dimension 570x270x355 INSTALLATION INSTRUCTION The machine is equipped with power voltage compensation system. When power voltage fluctuates between±10% of rated voltage, it still can work normally.
Page 5: Panel Function Instruction
voltage grade. Make sure there is no mistake and the voltage of power supply does not exceed permission range. After the above job, installation is finished and welding is available. PANEL FUNCTION INSTRUCTION The panel picture above is for reference only. If any difference with the real machine, please follow with the real machine.
Page 6: Operation Instruction
OPERATION INSTRUCTION WARNING ！ Before operation , please make sure all the power is turned off. The right process is to connect the welding cable and ground cable to the machine first, and make sure they are firmly connected and then put the power plug to the power source. 1.
Page 7: Notes Or Preventive Measures
NOTES OR PREVENTIVE MEASURES 1. Environment 1） The machine should be operated in dry environments with humidity levels of max 90%. 2） Ambient temperature should be between -10 to 40 degrees centigrade. 3） Avoid welding in sunshine or drippings. Do not let water sprinkle on the machine. 4）...
Page 8: Maintenance
MAINTENANCE 1. Remove dust by dry and clean compressed air regularly. If welding machine is operated in environment where strong smoke and polluted air is present, the machine needs to be cleaned at least once a month. 2. Pressure of compressed air must be within reasonable range in order to prevent damage to small and sensitive components in the machine.
Page 9: Troubleshooting
TROUBLESHOOTING Notes: The following operations must be performed by qualified electricians with valid certifications. Before maintenance,please contact with us for professional suggestion. Problem Cause Solution The machine does not 1, No power input 1, Check circuit or fuse of power work when the main switch 2, Power cord or power plug is source...