Download Print this page

Camplex CMX-HDMIF User Manual page 2

Hdmi to optical fiber converter

Advertisement

4. Installation / Application
4.1 Connect Extender
HDMI
in
HDMI Video Source
HDMI Extender TX
(sender)
4.2 Connect IR module (this is optional)
Connect the IR sender to the HDMI extender sender "IR in" port;
Connect the IR receiver to the HDMI extender receiver "IR out" port;
Note:
Use the IR remote control of your HDMI source device at the receive end to operate and
control it.
5. Basic Troubleshooting
Q1: The yellow LED fl ickers but slowly?
A1: 1) Check the connection of extender/sender and receiver.
2) Check that the HDMI video source is outputting a signal by attaching it to a local
display.
3) Check and replace the HDMI cable to both the sender and receiver units.
Q2: The yellow LED fl ickers quickly but no picture outputs?
A2: 1) If input video source is an HDMI graphic card, please make sure the HDMI graph-
ic card output resolution is supported by your HDMI display.
2) Double check HDMI cable connections of both the sender and receiver.
3) Check and replace the HDMI cable to both the sender and receiver units.
4) Be certain you are using a singlemode fi ber optic cable.
HDMI
out
HDMI Extender RX
(receiver)
Q3: Yellow LED doesn't light?
A3: 1) Make sure the fi ber optic cable is connected correctly and securely.
2) Check the fi ber optic cable end. Detach, clean properly and reinsert.
3) Make sure your fi ber optic cable is a singlemode cable.
Q4: HDMI output display is abnormal or fl ickers?
A4: Press the "reset" button to go-back to default setting. Make sure your display sup-
ports the resolution of the source.
Q5: The IR remote control doesn't work?
A5: 1) Check the connection of IR blaster and IR receiver and make sure it's correct.
2) Make sure the IR remote control can support a 38kHz signal.
6. Technical Specifi cations
Power Adapter
DC5V/2A (2 included)
DDC Signal Voltage
TMDS Bandwidth
HDMI
HDMI Input Resolution
Parameters
Supported
HDMI Output
Resolution Supported
Fiber Wavelength
Fiber Connection
Fiber Type/Distance
Linked-Circuit Loss
Output Power
Receive Sensitivity
IR Remote
Supports 38kHz
Power
Tx: 5W / Rx: 5W
Consumption
Dimensions
Each Tx/Rx Unit: 5"L x 3.375"W x 0.875"H (13 x 8.5 x 2.4 cm)
www.camplex.com
5Vp-p (TTL)
10.2Gpbs
480i@60Hz, 480p@60Hz,
576i@50Hz, 576p@50Hz,
720p@50/60Hz,
1080i@50/60Hz, 1080p@50/60Hz
480p@60Hz, 576p@50Hz,
720p@50/60Hz, 1080p@50/60Hz
1310nm
ST Connectors
SMF (single mode fi ber) / 0-20Km
≤14dB
≥11dBm
≤-32dBm

Advertisement

loading