Advertisement
■ Accessories
Accessories
D-SUB 9 pin
Male connector
26 pin cable
with a connector
■ Wiring connection
1. To use the BLG-IF1 with the driver, the attached D-SUB 9 pin connector needs to be installed to the box to
connect with the driver. Adjust the length of the 26 pin cables and position of the D-SUB 9 pin connector based
on the use conditions, and connect the D-SUB 9 pin connector and the 26 pin connector.
2. To connect with external devices such as a PLC (In some usage conditions, also connect to the COM as needed
basis.)
Input circuit (reference)
Output circuit
* Option BLG-BC2 I/O Cable
BLG-BC2-3010
* Note: Make sure to turn on the power supply after doing all the necessary wiring connection to prevent malfunction,
and not to operate the driver while inputting the signals from external devices.
No. of pcs
Details
1
(Please connect it with the BLG-BC2 series)
* Note: To connect with the BLG-BC2
The BLG-BC2 I/O Cable "BLG-BC2-3010" needs to be purchased additionally.
1
(Please connect it with PLC)
* Note: To connect with a PC
A Commercial D-SUB 9 pin connector and a RS-232C cable (Straight cable) need
to be purchased additionally.
Internal circuit
Internal circuit
Internal circuit
Length: 3m
D-SUB 9 pin female
Jackφ2.5
source current
sink current
2/2
ET-E011_BLG-IF1_17A
Connect COM (#5 or 6)
to GND.
To do this connection,
#26 needs to be used.
Connect COM to +V
(8-28V).
To do this connection,
#25 needs to be used.
* #25 and 26 need to be
shared with the external
input power source to do
the connections above.
Advertisement
