Advertisement
4.
Attach Splice Tape to Carrier Tape.
Fold the splice tape over so the ends of both sides touch the carrier tape. The
side without the sprocket holes should secure to the ledge of the carrier tape.
The positioning pins should protrude through the sprocket holes on the other
side.
5.
Apply Compressor to splice.
Press the compressor down to seal the splice to the carrier tape on the
sprocket side of the tape. Use a fingertip to press down on the other side to
ensure the splice is sealed properly.
NOTE: For 8 mm carrier tape, the compressor fits in the peg holes so the carrier tape
goes through the notch. For carrier tape larger than 8 mm, the compressor must be
turned around.
6.
Confirm splice quality.
Remove the carrier tape and make sure it is spliced correctly. Pull the tab to
remove the pink transparent release tape. Rub thumb over splice to ensure
sufficient splice adhesion to the carrier tape.
7.
Trim excess splice tape.
Position the spliced carrier tape on the trimmer and gently press it up against
the two shoulders. Press the trimmer down to trim the excess splice tape.
To trim the opposite side of the spliced carrier tape, position the reel stand on
the other side of the tape splicer. Repeat Steps 6 and 7.
Detailed User's Guides, maintenance instructions and troubleshooting are available on the V-TEK, Inc. website:
www.vtekusa.com.
Contact Information
V-TEK, Inc.
751 Summit Ave
Mankato, MN 56001
D291720.11
TS-100 Quick Start Guide
TEL: (507) 387-2039
website:
http://www.vtekusa.com
email: service@vtekusa.com
Page 2 of 2
Rev. 0, 5/31/16
Advertisement
