ESC X160 User Manual

X
User Manual
V1.0

Disclaimer and Warning

Thank you for purchasing X160.
Please read this instruction manual carefully before using this product. By using this product, you hereby
agree to this disclaimer and signify that you have read it in full.
Please mount and use this product as per this manual strictly. As manufacturer has no control over use,
setup, final assembly, modification (including use other parts such as motor, ESC, propeller etc),no ability
shall be assumed nor accepted for any resulting damage or injury.
As it may cause wireless interference in the living environment, please take effective measures to avoid it.
Any parts of this manual is subjected to change without prior notice.
Any problems while mounting this frame, please contact with us or authorized agents.

Introduction

X160 is the micro racer for FPV hobbyist. It is a high-integrated product with highly flexible control.
Equipped with motor 1104-4000KV, propeller 3x2 as well as the popular BLheli 10A esc (Oneshot support).
Flight range of remote control more than 1000 meters.
To gain the quality and real-time shoot for FPV, X160 also combines 5.8G 32CH 200mW transmitter(the
switch can shift between 20mW and 200mW) with 1/3''CMOS lens, which supports 127 or wider 160°
shootings and every moment brings you the exciting FPV experience.
This latest V3 with OSD for the video, the real-time status will be returned back to the display. Flight control
SP F3 flash with CleanFlight, just connect the battery, receiver and set the remote control to use.
Flight control SP F3 CleanFlight
Propeller 3x2"
ESC 10A（BLHeli FW)
Lens 1/3" CMOS lens FOV:160°
148
[1]
[2]
[1]. Dip FM Switch
[2]. Mini 1/3'' CMOS lens
[3]. 5.8G antennas
[4]. Propeller 3x2''
[5]. Motor 1104
[6]. PWM input PWM output
CH 1-6 for receiver signal input
(CH 1 is also the PPM input port)
(V3)

X160 Power Set

Motor
Transmitter
Battery
(Exclude)
41
[3]
[7]. USB port: Connect flight control with computer
[8]. PWM1: CH 1-4 for motor signal output)
[9]. UART3: SBUS receiver input port
[10]. OSD tune port
[11]. UART1: Connect OSD
[12]. SWD port: For factory production
[13]. I2C: External device (such as bluetooth )
[14]. PWM2: CH 5-8 for motor signal output
[15]. UART2: Spare
[16]. 8PIN input port: CH7 and CH8 are double input port
For signal input of CH7 and CH8 or ultrasound signal input port
1104/4000KV
5.8G 200mW/32CH
RCMD 3S 450-1000MAH（35C）

Box list

X160 frame 1pcs
Propeller 3x2'' 2pairs
5.8G Antennas 1pcs
Landing gear 4pcs
Screw M2x6mm 10pcs
[4]
[6]
[7]
[5]
[9]
Weight:143g
(EXclude battery)
[10]
[8]
[11] [12] [13]
[15]
[16]
[14]