Do you have a question about the SW-1070 and is the answer not in the manual?
Questions and answers
Jacqueline
April 11, 2025
My alarm is constantly bleeping, I think the battery needs changing, but where is it and how do I do it?
1 comments:
Mr. Anderson
April 11, 2025
To change the battery in the HKC SW-1070 alarm:
1. Open the RF-ECHO device by removing the cover lid screws. 2. Unplug the old battery pack. 3. Plug in the new lithium battery pack (CR123A 3V). 4. Close the device but do not screw it shut until testing is complete. 5. It is recommended to change the battery every 3 years.
Note: If Status LEDs are enabled, battery replacement may be needed every 6 to 8 months.
Page 7
Power Fault Alarm PLAY QUIT pqrs wxyz LIGHT Complies with EN 50131 Grade 2 Class II prev next System Arming Power Fault Alarm PLAY QUIT pqrs wxyz LIGHT Complies with EN 50131 Grade 2 Class II prev next System Arming NOTES: Zones inhibited in Part Set will remain inactive for the duration of system set.
Need help?
Do you have a question about the SW-1070 and is the answer not in the manual?
Questions and answers
My alarm is constantly bleeping, I think the battery needs changing, but where is it and how do I do it?
To change the battery in the HKC SW-1070 alarm:
1. Open the RF-ECHO device by removing the cover lid screws.
2. Unplug the old battery pack.
3. Plug in the new lithium battery pack (CR123A 3V).
4. Close the device but do not screw it shut until testing is complete.
5. It is recommended to change the battery every 3 years.
Note: If Status LEDs are enabled, battery replacement may be needed every 6 to 8 months.
This answer is automatically generated