FluidWatch Installation Manual The following instructions describe the installation and operating procedures for FluidWatch Models FW 25-50, FW 25-75 and FW 25-100 Leak Detection Monitoring Systems. Custom length systems are also available. Introduction The FluidWatch system consists of a solid-state electronic monitoring unit connected by jumper cable to a sensor cable.
FluidWatch Installation Manual System Configuration There are several user selectable options for configuring the FluidWatch Leak Detection System. Refer to Figure 1 to locate different jumpers and terminal strips that are referenced in the following descriptions. Jumpers are rectangular plugs, which connect two pins together on the circuit board. Power to the unit should be turned off before making any internal adjustments to the monitoring unit.
FluidWatch Installation Manual Silence On Reset Enable Jumper JP2 is normally installed to allow the system to automatically silence the alarm if the cable dries. To disable this feature and require the system to be manually silenced by pressing the “silence” button, remove jumper JP2 and place it back on one of the two pins at connector JP2.
FluidWatch Installation Manual Warranty Seller warrants that the FluidWatch™ Leak Detection System (the “System”) will be free from defects in materials and workmanship for a period of one year from the date of shipment by Seller to Buyer. Seller is not responsible for damage to the System occurring in transit or arising from the installation, alteration or repair of the System by persons other than Seller’s employees, or from any abnormal or improper use of, negligence with respect to or accident affecting the System.