IMMOTOR GO Quick Start Manual
  1. Manuals
  2. Brands
  3. IMMOTOR Manuals
  4. Scooter
  5. GO
  6. Quick start manual

IMMOTOR GO Quick Start Manual

Hide thumbs Also See for GO:

Advertisement

Table of Contents

IM M OTOR G O
Q U I C K S TA RT G U ID E

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GO and is the answer not in the manual?

Questions and answers

Edwin Hackett
May 16, 2025

is there a schematic for the immotors go scooter. Specifically I am looking For the Motor controller location, also when I got the scooter the handlebars were broken so I need to know about the wiring as fas as the left and right handlebars are concerned. Have not been able to find any resources on used or replacement parts so I must fabricate something. ANy information is apreciated

0

Related Manuals for IMMOTOR GO

Summary of Contents for IMMOTOR GO

  • Page 1 IM M OTOR G O Q U I C K S TA RT G U ID E...

  • Page 2: Before Your First Ride

    User Tutorial in the Immotor GO App before your first ride. Use your mobile device (Android or iOS) to download the Immotor GO App, and be sure to follow the instructions before use. to 4 mph (6 km/h) for the first 0.6 mile (~1km) until you have completed the New Rider Tutorial.

  • Page 3: Features And Controls

    Features and Controls LCD Display Incoming Text Cruise Control Message Handle Bar Headlight Missed Calls Computer Error GPS Signal Stem Lock / Unlock Time 88:88 Speed Mode MODE Bluetooth LCD Display Odometer 8888.8km Battery Mileage 88.8km T-Handle Speedometer Remaining Range 88.8 km 88.8km/h Headlight...
  • Page 4 When folding up your Immotor GO, never place (Figure A) your hands or fingers between footboard and main body Pull up the “T” handle until it stops (About 5 inches) *Tutorial videos are available on the App and at www.immotor.com...
  • Page 5 STEP 2 STEP 3 “T” Handle “T” Handle Main Body Main Body Stem Footboard Foot board While holding “T” handle, lift trigger latch With one hand on the “T” handle in up position, step on the footboard, to disengage footboard from body. with one foot, and with opposite hand push red button located under the 2 &3) Gently kick rear wheels away from main body as you...
  • Page 6 STEP 4 Select Handle Bar Height Stem Once handle bars are locked into their horizontal position, you may select one of 3 preset handle bar/ stem heights by pressing the red button and sliding the stem up • Once stem is locked into an “up” position, lift up or down until it locks at desired height.
  • Page 7 Release the two metal clips by lifting on tabs located in the center, then pivot them outward. *Tutorial videos are available on the App and at www.immotor.com...
  • Page 8 STEP 2 How to remove the Super Batteries Insert finger in the battery compartment slot, press down With the 3-pin contact facing down (and logo on top), on the latch and pull away from main body to open the slide the Super Battery (2) into the storage slots. battery compartment.
  • Page 9 Press red button located under the “T” handle with thumb and pull “T” handle up to extend. Raise handle bars. *Tutorial videos are available on the App and at www.immotor.com...
  • Page 10 Ride While holding the handle bar with one hand, lift the trigger latch to release the footboard. Lower the footboard toward the ground until it latches onto the rear axle. *Tutorial videos are available on the App and at www.immotor.com...
  • Page 11 “T” handle to release and push down until retracted fully into the main body. Lift the trigger latch to release rear wheels and fold/lock the wheels into Stand-By mode. *Tutorial videos are available on the App and at www.immotor.com...
  • Page 12 *The body should now be connected/latched to the footboard. Using “T”handle or handle bars, lift GO upwards again until it stands and wheels lock into Power Assist mode. *Tutorial videos are available on the App and at www.immotor.com...
  • Page 13 Press the square button behind the handle bar to release the handle bars. Fold the handle bars down until it is parallel with the stem. Repeat with other handle bar. *Tutorial videos are available on the App and at www.immotor.com...
  • Page 14 STEP 2 STEP 3 “T” Handle Main body Stem Footboard While holding the “T” handle with one hand, step on the top of the foot latch located where the footboard meets the body to release the hinge. Pivot the whole body down using “T” handle to connect •...
  • Page 15 STEP 5 Power Assist Mode • Push the handle down to close Using “T” handle, lift GO upwards again until it stands and locks into Power Assist mode. 2&3) Lift the latch to release rear wheels and fold/lock the wheels into Stand-By Mode.
  • Page 16 How to use the Immotor GO in Stand-By Mode Pull effortlessly with you like a rollable suitcase. Use the built-in handle on the back to carry Ready for use - in office, restaurant or home. upstairs or put into trunk of car.

  • Page 17: How To Charge

    Two ways to charge the batteries Remove Super Batteries, place Connect the AC Charger to in dual battery dock charger and your GO (see below) and then Squeeze accelerator lever Have fun! plug into outlet. (This accessory is plug into an outlet.

  • Page 18: Product Information

    ·QUICK START GUIDE FILE AND GERMAN, FRENCH, AND SPANISH TRANSLATIONS ARE AVAILABLE ONLINE AT WWW.IMMOTOR.COM. ·Please read the “Immotor GO User Manual” carefully before using it. You can download the file from www.immotor.com · Visit www.immotor.com for technical support and FAQ of Immotor GO ·...

Table of Contents