Table of Contents
Advertisement
Quick Links
Overview
This Quick Start Guide will take you through the steps to set-up your service shown below. Please make sure you
complete all the steps in the order they are shown to avoid any problems with the configuration of your service.
Step 1 Your service configuration information
Step 2 Understanding your Usernames & Passwords
Step 3 Installing your router & configuring your PC
Step 4 Configuring your modem to connect to the Internet
Step 5 Completing the service activation process
Step 6 Reconnecting to the Internet
Step 1 Your service configuration information
Your service configuration information is shown below. You will need this information when setting up your DSL connection
for the first time. Please keep this information in a safe place for future reference.
Please be aware that the billing for your service will commence on [date].
Service Details
ADSL Plan
ADSL Telephone Number
Supplied Hardware
Permanent Dynamic IP Address
Commander Primary DNS
Commander Secondary DNS
Additional Network IPs
Network 1
Network 2
ADSL Connection Username & Password
Username
Password
Email configuration
Incoming mail server (receive)
Outgoing mail server (send)
Online Support Centre Username & Password
Username
Password
DSL 300+ QUICK START GUIDE
203 . 191 . 160 . 68
203 . 191 . 160 . 83
pop.commander360.com
smtp.commander360.com
@commander360.com.au
Page 1
Advertisement
Table of Contents
Summary of Contents for Commander DSL 300+
- Page 1 Please be aware that the billing for your service will commence on [date]. Service Details ADSL Plan ADSL Telephone Number Supplied Hardware Permanent Dynamic IP Address Commander Primary DNS 203 . 191 . 160 . 68 Commander Secondary DNS 203 . 191 . 160 . 83 Additional Network IPs Network 1 Network 2 ADSL Connection Username &...
- Page 2 [Your Telephone Number]@commander360.com Password: 8 alphanumeric characters Your username cannot be changed as it is a unique identifier on the Commander network. If you wish to change your ADSL connection password please log into the Online Support Centre at http://www.commander360.com/support.html After you have changed your details you will be asked to re-connect your service to update your settings.
- Page 3 1. The POWER LED should turn green and stay on. After approximately five seconds the STATUS LED should begin to flash or blink continuously. If it does not, please contact Commander. 2. Connect one end of the standard telephone cable (RJ11 cable), which came with the DSL-300+ modem into the ADSL PORT (RJ11) on the rear panel of the DSL-300+ and the other end into the telephone socket of the telephone service that has been enabled for DSL.
- Page 4 6. The D-Link Account Configuration web page should appear. 7. In the field User Name enter the username provided by Commander on the configuration sheet, which should have been provided to you at the time Commander advised you that your DSL service was active.
- Page 5 Step 4 Completing the service activation process Once you have completed the installation and connection of your hardware you will be taken to the Commander Self- Activation Screen. This screen will guide you through the rest of the process to configure your service. You will be asked to complete the following steps before your connection to the Internet is established:- 1.
Need help?
Do you have a question about the DSL 300+ and is the answer not in the manual?
Questions and answers