Artesyn COMX-CAR-210 Quick Start Manual

COMX-CAR-210

Quick Start Guide

P/N:6806800L15B (August 2014)
1
What's in the Box?
Make sure you receive all items of
your shipment:
• One COMX-CAR-210
• One printed copy of Quick Start
Guide (this document)
• One printed copy of Safety Notes
Summary
• Any other optional items that
you ordered
When installing or servicing the
module or accessories, strictly
observe the safety precautions
in the Safety Notes Summary.
Otherwise, personal injury or
property damage may occur.
2
Observe ESD-safe
Measures
• Use either a properly grounded ESD
wrist strap or make sure that you are
working in an ESD-safe environ-
ment.
• Connect to the ESD connector at the
front or the rear of the system.
3
Prepare the Installation
Site
• For information on the environmen-
tal and power requirements, see the
COMX-CAR-210 Installation and Use
manual.
• Operating temperatures refer to the
temperature of the air circulating
around the blade and not to the
actual component temperature.
4
Installation of the Heat
Spreader/Heat Sink
1. Check the thermal interface mate-
rial pads on the heat spreader/heat
sink. Make sure the pads are aligned
to their corresponding components
on the COM Express module.
2. Align the standoffs of the heat
spreader/heat sink with the screw
holes on the COM Express module.
3. Hold the heat spreader/heat sink
and the COM Express module
together, and then turn them over.
4. Attach the heat spreader/heat sink
to the COM Express module by using
the standoffs (male/female type).