Videsur-electronic VSDP82IR User Manual

User Manual

Thank you for using our company's
products,please read the user manual
carefully before using this product. When
you start to use this equipment, we
believe that you have read the user
manual carefully.
Attentions：
Secure Startup: Avoid turning on
the equipment in the very dry or
humid environment, to prevent
damaging of the equipment；
Using qualified maintenance
services:Only qualified
maintenance personnel can repair
the equipment, Pleasedo not
dismantle the equipment by
yourself
Connected to other devices:
When connected to other
equipments, please read theuser
manual of the equipment to obtain
detailed safety instructions, do not
connect to other device that the
equipment not equipped with.
Backup Important data of this
equipment please do a back up, any
error o p er a ti o n a l m et h o ds
resulting in paper loss,t h e
c om p a n y s h al l n o t b e
responsible for.
Host Interface：
①Video/Photograph ②Laser Light On/Off
③Playback ④TV OUT ⑤Mini USB
⑥Mode Change Switch ⑦MIC/LED
Indicator Light ⑧Reset ⑨
TF Slot
⑩DC Port
Operation Instruction:
Note:The following operations are
required to operate in standby mode and
ensure that the identified T-Flash card
was inserted to the card slot properly。
Power On：When connect vehicle power
supply, the device will automatic turn on
and enters the standby state. If not
connect the vehicle power, press ①for
three seconds, the green light is on, it
indicates that the device is turned on and
has entered standby mode.
In tandby status, It is motion detection
mode if ⑥ in the "M" position;it is video
mode if ⑥ in the "V" position; it is
photograph mode if ⑥ in the "P" position
Laser light: In tandby status,Press ② key,
laser light is on, loosen ② key, laser light
is off.
Motion Detection：In standby Status,
move ⑥ to "M" position ,it indicates that
the equipment has entered the motion
detection mode, when the camera lens
detectes moving objects that start
recording, then blue light is on. It will
Automatic record video for ten minutes
and save the file when the moving
objects detected. If the moving object is
detected continuously,the device will
automatic record video continuously.
⑥
Video：In standby Status, move to
①
"V"position, short press once, blue
light is on, then entered to video mode. In
①
vide mode, short press once, two
seconds later the green light on, video
files saved automatically ,the device
automatic returns to standby mode; if
need video recording one more
time,please repeat the above operation.
The device default to save a video every
five minutes.
Photograph：In standby status, move⑥