leave your drinks cooler for 2hours This appliance is intended to be used in households but is not intended to be Before switching on leave your drinks cooler used in applications such as; upright for 2hours to allow the coolant fluid time to –...
Page 3
1. Tilt the unit slightly towards the rear Remove the top left screw cover. and prop it securely. Two people are required to tilt the unit during the door reversal process. Remove the screws and bottom hinge. Then remove the adjustable feet from both side.
Page 4
7. Refit the bracket fitting the bottom 11. Put the hinge cover and the screw hinge pin. cover back. Replace both adjustable feet. Screw Place the door back on. Ensure the 12. With the door closed, check that the door is aligned horizontally and door is aligned horizontally and vertically vertically so that the seals are and that the seals are closed on all sides...
Plug in and switch on Temperature controls temperature setting The drinks cooler runs on an electricity supply of 220-240V 50Hz and must be earthed. Your drinks cooler is factory set to provide your drinks with an optimum environment for storage Plug in the drinks cooler and switch it on at the and longevity.
Changing the internal light Glass door condensation DF72G only. From time to time, depending on the extenal temperature humidity level, some Before carrying out the bulb replacement always condensation may appear on the glass door. This switch off and disconnect the electricity supply. phenomenon has no effect on the product and will disappear when the difference between the To replace the bulb:...
Page 7
Cleaning your drinks cooler Defrosting your drinks cooler on the outside Your drinks cooler automatically defrosts regularly, every time it finishes a cooling cycle. The defrost Use a good wax furniture polish to clean y our water will collect in the trough, located at the back drinks cooler’s exterior.
Safety Useful hints Ensure that the appliance is earthed. If your appliance is to be out of service for any Ensure that the appliance is disconnected from the length of time ensure that the interior is carefully mains supply before atten cleaned and dried.
Page 10
Disposal Your cabinet is CFC and HCFC free and therefore has no ozone depletion potential (zero ODP). However, all refrigeration appliances should be disposed of in a responsible manner. Ensure that none of the pipes on the back of the appliance are damaged prior to disposal.
Page 12
The drinks cooler has been treated in an abnormal or abusive manner The drinks cooler has been used for industrial or commercial purposes. Any repair work has been carried out by any person other than a Lec approved engineer. Any parts have been fitted which are not genuine Lec approved parts.
Need help?
Do you have a question about the DF50B and is the answer not in the manual?
Questions and answers