Connecting The Transmitter To Your Audio Source; Connecting To A Headphone Output; Connecting To A Line Output; Setting Up The System - Professor CP3D-WL-2.4G-A101 User Instructions

F-5
DC 5V DC 5V Audio in Audio in Audio out Audio out
F-6
DC 5V DC 5V Audio in Audio in Audio out Audio out
charging jack of headphone and connect to
transmitter s DC jack. '
4. If the transmitter connecting with electricity,
the POWER LED will light on and the
battery be being charged via charging
cable.
5. By the charging system, the batteries will
be fully charged for 8 ~ 10 hours.
5.2 Connecting the Transmitter to your
Audio Source

5.2.1 Connecting to a Headphone Output

(Refer to F-5)
1. Before connecting the transmitter to your
audio source, please switch the audio
device OFF.
2. Connect the stereo mini jack plug of the
jack cable to the headphone output of your
audio source. And consequently, plug the
supplied connecting cables to jack cable.
3.
Plug the red RCA connector (Right
Channels Charge
2
3
1
0 4
7 5
6
White
Red
Channels Charge
2
3
1
0 4
7 5
6
White
Red
Left(White)
Right(Red)
Audio Out
(Stereo Out)
channel) on the supplied jack cable into the
red AUDIO IN (R) socket and the white
RCA connector (Left channel) on the
supplied jack cable into the white AUDIO
IN (L) socket on the transmitter s rear
panel.
5.2.2 Connecting to a LINE Output (Stereo
L/R) (Refer to F-6)
1. Before connecting the transmitter to your
audio source, please switch the audio
device OFF.
2. Use the supplied RCA cable to connect the
white LINE OUT (L) jack on your audio
source to the white AUDIO IN (L) jack on
the transmitter rear panel and the red LINE
OUT (R) jack on your audio source to the
red AUDIO IN (R) jack.

5.3 Setting Up the System

1. If the transmitter connects to the electricity,
the POWER LED will light on
4
2.4GHz
'
.