Advertisement
Quick Links
pakedgedevice&software
P8 -
Boot Sequence Power Distribution Unit with Remote Power Cycling
Quick Start-
Quick Installation
Power on the P8 and connect it to the Local Area Network (LAN) via the 10/100 Base-T Ethernet
1.
port.
By default, the P8 will begin to power on the outlets beginning with the "Modem" outlet. After 60
2.
seconds, it will power on the "Router" outlet and then continue to power on the remaining outlets.
To access the P8's web interface, make sure that your computer's IP address is on the same
3.
subnet as the P8, open up a web browser and enter 192.168.1.210 (P8's default IP address) in
the address bar.
version 1.0
inc.
Advertisement
Summary of Contents for Pakedge Device & Software P8
- Page 1 1.0 Quick Installation Power on the P8 and connect it to the Local Area Network (LAN) via the 10/100 Base-T Ethernet port. By default, the P8 will begin to power on the outlets beginning with the “Modem” outlet. After 60 seconds, it will power on the “Router”...
- Page 2 Auto-Ping and equipment reboot: If you connect a device to a specific outlet and provide the P8 with the IP address of the device, the P8 will ping the device every 15 seconds and if it does not get a response, the device will be rebooted.
- Page 3 Caution: Please do not press the “upgrade” button without the manufacture’s permission. This may stop the unit from functioning correctly. Please read user manual for further instructions on how to use the P8. Model No.: P8 Input: 100V-120V Output: 100V-120V, MAX.15A...