Watercool HEATKILLER GPU-X3 GTX480 Assembly Manual

Assembly instructions
HEATKILLER® GPU-X³
GTX465/470 and GTX480
The unique design of the HEATKILLER® GPU-X³ guarantees outstanding performance. A cooling performance in
the range of current high-end CPU coolers, a flat design as well as top quality materials distinguish the new GPU-
X³ series.
The bottom plate consists of pure copper. The cooling structure of the GPU is extremely fine-tuned and offers a
higher performance than most CPU coolers. The thin base ensures even more performance.
Dimensions (LxBxH)
Weight
Material (bottom/cover)
Connections
Temperature-resistant up to
Compatible with
Note: You will find coloured assembly instructions in Pdf format in the service area of our homepage.
( www.watercool.de )
Attention: The Watercool company assumes no liability for any damages caused to hardware. If
uncertain hire a specialist to carry out the modification, or use our modification service.
By disassembling the original cooler you may cause the manufacturer´s warranty to become void, if
uncertain contact the manufacturer of the Graphic card.

Preparation of the Graphic card

Remove the original heatsink and all remnants of the thermal pads.
Place the pre-cut pads on the graphics card as illustrated. Normally, both sides of the pads are covered with a
protective film which must be removed before the installation.
HEATKILLER® GPU-X³GTX 465/470
161,0 x 117,0 x 11.5mm
800g
CU / VA
G ¼ Zoll
80° C
Nvidia GeForce GTX465/470
HEATKILLER® GPU-X³GTX 480
172,0 x 117,0 x 11,5mm
850g
CU / VA
G ¼ Zoll
80° C
Nvidia GeForce GTX480