Table of Contents
Advertisement
96 | DOC notice for Canada
present are connected together. This precaution may be particularly important in
rural areas.
CAUTION: Do not attempt to make such connections yourself; contact the
appropriate inspection authority or electrician.
IC Ringer Equivalency Number (IC REN): 0.3
The IC Ren number assigned to each terminal device denotes the percentage of
the total load to be connected to a telephone loop used by the device, without
overloading. The termination of a loop may consist of any combination of devices
subject only to the requirement that the total of the Load Number of all devices
does not exceed 100. This requirement is to prevent overloading of the
telephone loop. This digital apparatus does not exceed the Class B limits for the
radio noise emissions from the digital apparatus set out in the Radio Interference
Regulation of the Canadian Department of Communications.
Le present appareil numerique n'emet pa de burits radioelectriques depassant les
limites applicables aux appareil numerique de la classe B prescritesdans le
Reglement sur le brouillage radioelectrique edicte par le minestere des
Communication du Canada.
Caution: Always disconnect modem from telephone system when installing or
when covers are removed from the host product.
Attention: Debrancher la carte modem du reseau telephonique lors de
l'installation les couvercles de l'appareil hote sont enleves.
International standards
This product was designed to meet the requirements applicable to the following
Directives:
Low Voltage Directive (72/23/EEC) as modified by amending Directive (93/68/
EEC) thereby covering the standards of:
•
IEC 950 / EN60950 2nd Edition, 1991+Amd.1, 1992+Amd.2, 1993+Amd.3,
1995+Amd.4, 1996. Safety Requirements of Information Technology
Equipment
•
EN60825-1: 1998, Safety of Laser products-Part 1: Equipment classification,
requirements and user's guide.
EMC Directive (89/336/EEC) as modified by amending Directive (93/68/EEC)
•
EN55013: 2000, Limits and methods of measurement of Radio disturbance
characteristics of broadcast receivers and associated equipment.
•
EN50082-1: 1997, Generic Immunity Standard Part 1: Residential,
Commercial and Light Industry
Commission Decision [(98/482/EC) CTR21] Attachment requirements for pan-
European approval for Connection to the Analog PSTN Networks.
However, due to differences between the individual PSTN's provided in different
countries the compliance of CTR21 does not of itself give an unconditional
assurance of successful operation on every PSTN termination point. In the event
of problems, you should contact your equipment supplier in the first instance.
Advertisement
Table of Contents
