BAK C-2300 Operating Manual

OPERATING MANUAL
Hot-Air Blower COMPACT

SAFETY

Danger to life when opening the tool, as live components and connec-
tions are exposed. The device must be disconnected from the mains sup-
ply before opening. Electric work shall only be operated by qualified
personal (according to TRBS 1203).
Danger of fire and explosion if the hot air blower is installed and used
incorrectly, particularly near flammable materials and explosive gases.
Not suitable for hazardous locations! The minimal air flow must not be
undercut.
Danger of burns
Do not touch heating element pipes and nozzles when hot. Let the device
cool down. Do not point the hot air jet at persons or animals.
The mains voltage specified on the device's type plate must correspond
to the mains voltage. Tools with a fix connection must be connected to a
separator (e.g. mains switch).
Special connecting conditions ac-
cording to IEC/EN 61000-3-11;
Consult your local electricity supplier if necessary.
GFCI/RCCB: for personal protection on building sites we strongly rec-
ommend to connect the tool to a GFCI (Ground Fault Circuit Interrupter)
or to a RCCB (Residual Current Circuit Breaker).
Device in protection class II"
The device must be supervised when in operation. The heat can reach
flammable materials that are out of view.
Protect the device from damp and wet!
Z = 0,039Ω + j 0,025Ω for short
max
time rating (30 minutes);
Z = 0,026Ω + j 0,016Ω for con-
max
tinous operation.