RIDGID R845 Operator's Manual page 17

OPERATION
OPERATING THE SAW
See Figures 14 - 15.
It is important to understand the correct method for operat-
ing the saw. Refer to the figures in this section to learn the
correct and incorrect ways for handling the saw.
WARNING:
To make sawing easier and safer, always maintain
proper control of the saw. Loss of control could
cause an accident resulting in possible serious
injury.
DANGER:
When lifting the saw from the workpiece, the blade
is exposed on the underside of the saw until the
lower blade guard closes. Make sure the lower
blade guard is closed before setting the saw
down.
To make the best possible cut, follow these helpful hints.
n Hold the saw firmly with both hands.
n Avoid placing your hand on the workpiece while making
a cut.
n Support the workpiece so that the cut (kerf) is always to
your side.
n Support the workpiece near the cut.
n Clamp the workpiece securely so that the workpiece will
not move during the cut.
n Always place the saw on the workpiece that is supported,
not the "cut off" piece.
n Place the workpiece with the "good" side down.
n Draw a guideline along the desired line of cut before
beginning your cut.
n Keep the cord away from the cutting area. Always place
the cord to prevent it from hanging up on the workpiece
while making a cut.
17
RIGHT
WRONG
Fig. 14
Fig. 15