Burning In The Fireplace Mode - Upland 207 Owner's Manual

BURNING IN THE FIREPLACE MODE

1. Open the firedoor and pull the baffle nearest the firedoor to the end
of the stove towards the firedoor.
2. Open the front doors and build a kindling fire to the rear of the
stove. Once the fire is burning well, add larger logs to the fire.
3. When a good fire is burning, close the flue damper to the point
where the fire still burns well but does not kick back smoke into the room.
4. Place the spark guard in front of the door opening. Directions for
installing the spark guard are found below.
NEVER LEAVE THE FIRE UNATTENDED WITHOUT THE SPARK
GUARD IN PLACE
Below is a diagram of the spark guard and instructions for installation.
To attach the spark guard to your Model #207, bend the mounting tabs on
the side out and the bottom tab down. Now, hook the bottom tab on the
bottom of the door opening and at the same time slide the side tabs behind
the lugs on the opened doors. If the doors are to be removed, put the hinge
pins from the doors in the hinge lugs on the front of the stove to hold the
screen in place.