Download Print this page

Catalinbread Epoch Pre EP-3 Manual page 6

Preamp / buffer

Advertisement

PURPOSE OF THE EPOCH
PRE?
While you could use it anyway you want to, our design intention is for the Epoch Pre to be
the very last pedal in the chain. Not only does it provide boost, it acts like a mastering
plug-in on the master fader - your whole pedalboard sounds bigger, lusher, wider. The
Epoch Pre bundles all the frequencies without squishing them like a compressor. For
moments where you're looking for your part to standout in the mix, engage the Boost!
Remember, the EP-3 was a three-pronged device, not only was it a delay but also a sonic
enhancer and live performance tool. The design of the Epoch Pre was intended to feature
its capabilities as a sonic enhancer. Folks with massive pedalboards will benefit from
having this at the end of the chain.
Then there's the buffer. First, a bit of context - as you now know, the preamp's volume
control is the mixer circuit from the EP-3. This mixer circuit has a relatively high output
impedance which is partly responsible for the warm sound usually associated with the
EP-3. But if you're running a long cable from the pedalboard to the amp, your signal can
become too dull and lifeless with just the preamp. Activating the buffer gives your
pedalboard a low-impedance, high-current feed to your amp so you could run 100' cable
and it would be fine. Back in the day, folks that used EP-3s typically had it on top of the
amp so the cable to the amp was usually short so there wasn't as much of a loading
problem. We designed the pedal so you could have the buffer always engaged. Even if
you're not using the preamp, your pedalboard will still get that benefit. But really, we doubt
anyone will turn this pedal off once they hear what it does for their pedalboard. Seriously!
ALSO - Not only can you use the Epoch Pre as a sonic enhancer / boost, you can use
it to turn DOWN the volume of your entire pedalboard without losing any tone or that
cranked-up feel. Perfect for late night playing! Just run your pedalboard into it and turn
the Balance control way down. You kind of have to experience it for yourself: retaining
the feel and sound of all your cranked up pedals, just without the volume.
If you're in minimalist mode, you can use the Epoch Pre just between your guitar and
amp and use it to boost and enhance your amp.

Advertisement

loading