Table of Contents 1.0 Getting Acquainted..........................1 2.0 Installing the DR-X-USB........................2 2.1 Installation pre-requirements......................2 2.2 Software installation..........................2 3.0 Start APTool............................3 3.1 FCC Approval Carrier test.........................4 3.2 FCC Approval Frequency Hopping....................5 3.3 Reading Tags.............................6 3.4 Writing Tags............................7 4.0 Set Password Dialogue...........................8 4.1 To set a password..........................8 4.2 To reset the password ( to default )....................8 5.0 Set Power Dialogue..........................9 5.1 To set the power level........................9...
Quick Reference Guide 1 Getting Acquainted Congratulations on purchasing a GTSYS Desktop RFID Reader. The reader can be delivered for 860 – 960 MHz (subject to regulatory region). The supported protocols are EPC Class1Gen2 / ISO18000-6C. It has been verified to work with tags from: Alien •...
Page 16
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized changes and modifications to this equipment.
Need help?
Do you have a question about the DR-E-USB and is the answer not in the manual?
Questions and answers