Advertisement
Quick Links
Advertisement
Summary of Contents for Jet Tent BUNKER
- Page 1 BUNKER OWNER’S MANUAL...
- Page 2 The Jet Tent Bunker require pegging to prevent from flying away in a gust of wind. Always anchor your Jet Tent Bunker. Enough Before using this product, read and fully understand: pegs and ropes are supplied to safely setup your tent in most (1) attached warnings;...
- Page 3 CONDENSATION Condensation is an unavoidable fact of physics. When warm, If cut appears on the Fly of the Bunker apply candle wax against moist air comes in contact with the cool tent fabric, it forms the ripped canvas to seal the hole and prevent of further tearing.
- Page 4 Place the fly on the side. arms. bed open with its side over into the up right Lay the folded tent on down. position. it’s side. Extend the front and Your Bunker should look like this. Put the fly on, rear first. rear poles.
- Page 5 Make sure the fly’s front door is opened Attach bottom clips to strengthen the structure. and put on, one corner at a time. OPTIONAL Your complete Bunker should look like this. You can gusset out the front door for some ventilation during bad weather.
- Page 6 Release all clips, holding the fly Release the fly’s front section first. Pull the fly away from the rear. from the bottom. Push the release buttons and collaspe the Turn the Bunker on its side front and rear poles. and push down to close.
- Page 7 2 protective flaps. arms in. Pinch point: Keep the mesh between the flaps Put the Bunker first in the bag. Lay the fly down neatly. Fold from top to bottom. Fold in Then the fly and close. the sides rougly to the size of the carry bag.
- Page 8 For more information visit: www.oztent.com e-mail: service@oztent.com Jet Tent is a registered Trademark of The Oztent Group Important Notice: Deatils of the product in the instruction illustrations may vary from the actual product.