Download Print this page

Labkotec MD-1 Installation Instructions Manual

Current loop to rs-232 converter

Table of Contents

Download this manual

Labkotec Oy

Myllyhaantie 6 1

FI-33960 PIRKKALA

FINLAND

Tel:

+358 29 006 260

Fax:

+358 29 006 1260

Email:

info@labkotec.fi

Internet: www.labkotec.fi

Labko MD-1

Current loop to RS-232 converter

Installation Instructions

We reserve the right for changes without notice

11.02.2010

D30646Ae

1/5

Table of Contents

Do you have a question about the MD-1 and is the answer not in the manual?

Page 1: Installation Instructions
FI-33960 PIRKKALA FINLAND Tel: +358 29 006 260 Fax: +358 29 006 1260 11.02.2010 Email: info@labkotec.fi D30646Ae Internet: www.labkotec.fi Labko MD-1 Current loop to RS-232 converter Installation Instructions opyright © 2010 Labkotec Oy We reserve the right for changes without notice...
Page 2 3.2 CONNECTIONS ............................4 3.3 TO BE NOTICED DURING INSTALLATION .................... 4 3.4 CABLING ..............................4 3.4.1 CABLING BETWEEN LPS-1 POWER SUPPLY AND MD-1 ............4 3.4.2 RS-232 CONNECTION ........................4 4. SERVICE AND REPAIR ..........................4 APPENDIX 1 CONNECTION DIAGRAM ......................5 Copyright ©...
Page 3 D30646Ae Installation Instructions 1. GENERAL 3. INSTALLATION AND ELECTRICAL CONNECTIONS MD-1 is a two-way protocol converter for communication between Labko 3000 probes and 3.1 CONSTRUCTION a computer program. MD-1 converts the RS-232 protocol information to a 20 mA digital current loop data e.g.
Page 4 3.3 TO BE NOTICED DURING in the D-connector end (e.g. at the PC), the shield INSTALLATION can be grounded e.g. by connecting the MD-1 conductor SHIELD12 to grounding or true earth. The device does not have a mains switch: 4. SERVICE AND REPAIR...