ZTW Beatles 20A BEC User Manual

ZTW Beatles 20A BEC User Manual

Beatles series brushless electronic speed controller (esc)

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Beatles 20A BEC and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ZTW Beatles 20A BEC

  • Page 2: Important Warnings

    Important Warnings ▲ ZTW is not responsible for your use of this product, or any damage or injuries you may cause or sustain as a result of its usage. ▲ Always place safety as priority when you use the product ▲...
  • Page 3: Speci Cations

    Specications: Cont.\Burst Battery cell Weight Size(mm) User Type PN#Model Current(A) NiXX\Lipo Output W*L*H Program Beatles 20A BEC 3020101 20A\30A 5-12NC\2-4Lipo 5V/2A 25x43x8 5-12NC\2-4Lipo Beatles 30A BEC 3030101 30A\40A 5V/2A 25x43x8 5-12NC\2-4Lipo Beatles 40A BEC 3040101 40A\50A 5V/3A 27x52x11 5-18NC\2-6Lipo Beatles 50A SBEC...
  • Page 4: Entering The Programming Mode

    Using the ESC 1. Turn on your radio and keep the throttle stick to the lowest position 2. Connect the battery pack to the ESC. 3. Motor emits two sets of audible tones in succession means the ESC is armed and ready to use.
  • Page 5 e. The system will exit automatically and save the setting after nishing the desired item. You only can setup one item at a time, if you want to program another item you need unplug the battery and power on the ESC again. 1) For Li-xx packs- number of cells are automatically calculated and requires no user input apart from dening the battery type.
  • Page 6 e. The system will exit automatically and save the setting after nishing the desired item. You only can setup one item at a time, if you want to program another item you need unplug the battery and power on the ESC again. Automatic (7-30 deg) –...
  • Page 7 8. Motor Rotation: Forward/ Reverse a. Turn on your radio and set the throttle stick to top positon (100%) b. Plug the battery pack into your controller c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear four single beeps to indicate you have successfully entered the programming mode d.
  • Page 8 Programming Tone Reference Table Programmable Item/Tones Option Throttle Calibration (Within the first 4 Sec) Brake Brake On/Off Battery type NiCad Lipo Low Voltage Cutoff Threshold Low2.8v/50% Medium3.0v/60% High3.2v/65% Restore Factory Setup Defaults Restore Timing Setup Automatic(7-30 ) Low(7-22 ) High(22-30 ) Acceleration Soft Normal...
  • Page 9: Frequently Asked Questions

    Frequently Asked Questions Q: Motor does n't work, but there are audible tones signal the number of cells after powering up ESC Possible cause: The ESC throttle calibration has not set up. Possible Solution: Set up the ESC throttle calibration Q: Motor does n't work and no audible tone emitted after connecting the battery.

Table of Contents

Save PDF