CastleNet BTC08R800 User Guide Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 3
End Product Labeling The final end product must be labeled in a visible area with the following: “Contains TX FCC ID: RK9-BTC08R800”. Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this...
CastleNet BTC08R800 User Guide Canada-Industry Canada (IC) Operation is subject to the following two conditions: this device may not cause interference and this device must accept any interference, including interference that may cause undesired operation of the device. IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment with IC radiation exposure limits set forth for an uncontrolled environment.
Page 5
The interface is HCI USB compliant with USB fully speed (12Mbits). The cable connection and PIN define of “Host I/F connector” from BT module (BTC08R800 series) to PC system is specially customized by OEM Laptop PC.
The module is embedded inside Notebook. If for testing purpose, we provide the “USB Testing Board” in order to let tester connect BTC08R800 via the special cable connection to PC externally. The USB Testing Board provides +5V/3.3V conversion from PC Host. Please plug into any USB port on your PC.