AwareGPS Installation Manual

Plug-In AwareGPS Tracking Device Installation Guide
1. Locate the OBDII Port in Your
Vehicle and Connect Your Device.
The connector is located under the dash and is
required to be within two feet of the steering
wheel. If you cannot locate the OBD connector,
please reference your vehicle's owner manual.
2. Start Your Vehicle, and Check the
Lights on the Device
The first time you plug-in the device, you will need to start your car in
order for the GPS tracking to start and for your vehicle to show up in the
Web site. Your vehicle must be outside and not in a covered area so that it will
receive GPS signal. When working properly, the blue light will blink once every 3
seconds and you will see a blinking green light. It may take up to
two hours to see your car's location on the map. You may use the
Off
OBD
(Orange)
Blinking
Blinking 1x/second
Cell
Blinking 1x/3seconds
(Blue)
Off
Solid
GPS
(Green)
Blinking
enclosed zip tie to secure the
O C G
device and prevent tampering.
Ignition's Off
Ignition's On
Searching for GSM Network
GSM Lock (connected to network)
Modem Reboot
Searching for Satellite
GPS Lock

IMPORTANT NOTICE: remove device before jump starting the vehicle.

Questions? Contact AwareGPS Customer Support:
Email: support@awaregps.com
Phone: 1-855-894-8729
When removing the device from your
vehicle, make sure you grasp the
device as close to the port as possible.