Shenzhen ATC Technology ATC-1000 Quick Start Manual

Quick Start Guide
TCP/IP TO RS-232/422/485 CONVERTER
MODEL ATC-1000
1
1
1
.

Check Package Content

■ATC-1000 unit
1Pcs
■Printed version of this ATC-1000 Quick Start Guide
1Pcs
■Software CD
■Ext power adapter
1Pcs
2
2

.Hardware Installation

■Connect an Ethernet cable to ATC-1000 unit if connecting
to a switch or cross-over direct to the PC as figure1
Figure1
■ATC-1000 10/100 Port t connect to Ethernet card use
coss-Through Cable as figure2
RS-232 Pinout：（DB9 Male）
（DB9Male）
PIN2
PIN3
PIN5
RS-422/485 Pinout：（Six Terminal from left）
Terminal
1Pcs
No
RS-422
RS-485
■ Connect the power adapter to ATC-1000 and other apply
power. Power from other device.(+9--+24V@500-100mA)。
3
3

. LED indication

LINK
ACT
PWR
4 4

.Software Installation

■ I
nsert the software CD and search for such as F:/Driver/
ATC-1000 folder to run VCOMSETUP.
Note: Be sure you have administrative rights &disable
Figure2
Signal I/O
RXD IN
TXD OUT
GND -
1 2 3 4 5
T+ T- R+ R- VIN
485+ 485- - - VIN
Indication Ethernet Link，Green on Ethernet Link
established。
Data Sending/Receiving between Serial and the
Ethernet
Indication Power
firewalls in windows XP
5 .
5

Configure the ATC-1000

■Use this section to set up your computer to assign it a static
IP address in the 192.168.2.2 to 192.168.2.254
subnet mask of 255.255.255.0. This is necessary to ensure
that your computer can communicate with your ATC-1000.
Your computer must have an Ethernet card and TCP/IP
installed. TCP/IP should already be installed on computer
using Windows 98/2000/XP and later operating systems.
■Open your web browser and type
browser's address box. This address is the factory set IP
Address of your ATC-1000. Press "Enter".
■The "Username and Password required"
"admin"
appear. Typing
"system"
field and typing
6
field. Click "OK". The setup screen will then appear.
GND
GND
range with a
http://192.168.2.1 in the
prompt box will
(default username) in the Username
(default password) in the Password