User Manual Farfi WE-N300 WiFi Rang Extender/Wireless Router/Access Point...
Page 2
-Make sure the route works normal. - Plug it into an electrical outlet ( closest to your primary router/WiFi access point ). -Use your Smart-Phone to connect with the repeater (find "FARFI" and connect with it). -Visit the IP address 192.168.10.1 from a web browser.
Page 3
-Log-in to the Admin Page by using "admin" for password, and then it will scan the exsisited wireless signals.
Page 4
-Choose your Router's/AP's network in the next window and select it. -Enter your Router's/AP's WIFI password in the Password/WIFI Key/Security key column and click on "Apply"...
Page 5
-In the next window, you'll see the reboot process .(Leave the device for 30 seconds to let it reboot itself).
Page 6
-Open the list of available networks again using your smartphone. Find out the New SSID "ChinaNet-Nytw-plus" and connect with it using the same password as of your primary router/AP.
Page 7
-if the internet works, unplug FARIFI WE-N300 and plug halfway between your Router and the Device intended for the internet usage/dead zones in your home where you were getting low to no WIFI signals. 2.Repeater Mode(Using Your Laptop) -Make sure the route works normal.
Page 8
-Choose the Repeater Mode and and click to get in.The repeater will scan the wireless signal arround it for about 30 seconds.
Page 10
-Choose your Router's/AP's network in the next window and select it.
Page 11
-Enter your Router's/AP's WIFI password in the Password/WIFI Key/Security key column and click on "Apply"...
Page 12
-In the next window, you'll see the reboot process .(Leave the device for 30 seconds to let it reboot itself).
Page 13
-Open the list of available networks again using your smartphone. Find out the New SSID "ChinaNet-Nytw-plus" and connect with it using the same password as of your primary router/AP.