Advertisement
6.1.3.
High temperature - When the temperature of the internal heat sink reaches 65°c, the solid state temperature sensor will
automatically shut down the unit. once it is allowed to cool, the unit may be restarted.
7. troUBLe ShootinG
Problem
unit will not operate
low output voltage.
low voltage alarm sounds continuously.
television interference
parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
weee regulations
dispose of this product at the end of its working life in compliance with the eu directive on Waste electrical and electronic
equipment (Weee). When the product is no longer required, it must be disposed of in an environmentally protective way.
contact your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMportant: no liability is accepted for incorrect use of this product.
warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
Possible cause
1. Poor dc contact
2. Battery voltage below 10V.
3. load draws too much power.
4. inverter in thermal shutdown.
5. Vehicle battery in poor condition.
6. internal fuses blown due to short
circuit.
check with voltmeter.
1. Bad connection or wiring.
2. low battery voltage.
1. inverter too close to the television.
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
Original Language Version
suggested remedy
1. check all dc contacts.
2. recharge or replace battery.
3. reduce load.
4. Allow inverter to cool.
5. check / replace battery.
6. contact local repair agent or sealey
technical help line for guidance.
use true rms voltmeter
1. check and tighten all dc connections.
2. recharge battery without load.
1. locate the inverter as far as possible
from the tV, antenna and other cables.
01284 757500
01284 703534
Pi1000.V3 | issue 1 19/04/16
www.sealey.co.uk
web
sales@sealey.co.uk
Advertisement
