Summary of Contents for Penner Cascade Elite 482000-1
Page 1
Cascade Elite Transfer Lift System Safe Operation, Daily Maintenance Instructions, & Parts Breakdown PENNER PATIENT CARE, INC Box 523 / 102 Grant St. Aurora, NE 68818 480745 Revision B – 08/08/11 1-866-PENNERS 1-866-736-6377 1-800-732-0717 E-mail Address: pennersales@hamilton.net Web Site: www.pennerpatientcare.com...
• General Precautions and Maintenance • System Cleaning (After Every Bath) • Daily Safety Checklist • Parts List Elite Penner Elite Transfer • Parts List Elite Penner Elite Transfer • Exploded View Elite Transfer Base • Exploded View Elite Transfer Pillar, Actuator, and Covers •...
Transfer Technical Identification Manufacturer: Penner Manufacturing Inc 102 Grant St / PO Box 503 Aurora, NE 68818 (402) 694-5003 Cascade Elite Transfer Lift Models: Model # 482000-1 Transfer Electric Cascade Elite Side Entry Without Scale R/H Model # 482000-1L Transfer Electric Cascade Elite Side Entry Without Scale L/H...
The caution heading identifies important maintenance and operation information. Failure to obey a caution warning may result in damage to the Penner Transfer System and may void the warranty. Left or Right When the terms “left” or “right” are used with reference to the tub, this means left or right as you look at the control panel from the seat end of the tub.
Penner Transfer Lift Criteria The Patient Must: a. Have no injuries or medical conditions that might be aggravated by the Penner Transfer Lift procedure. b. Weight less than 400 pounds.
Lifting with Standard Cascade Transfer Figure 1 System. The arm rests of Penner Transfers or Lift chairs can swing upwards and back, or be removed to provide a variety of options in providing care Push the Penner Transfer to the resident’s bed and position it for a normal...
1. Route the belt through the slots of the chair frame prior to placing the resident into the chair. 2. Transfer the resident into the Penner Lift or Transfer using the proper nursing transfer techniques. Bring the seat belt around the resident, to the D-ring connector.
Belting Technique and Transfer Procedure with the Penner Transfer Lift System continued WARNING Failure to insure hands, arms and legs are clear of any objects when transporting or lifting could result in injury to the resident or operator. Unlock the caster brakes and push the resident to the bathing area, being careful to avoid objects in the hallways or uneven floors.
Penner Transfer Procedure At the bathing area, position the Penner Transfer near the access water door of the Cascade tub. Ensure the water door is open wide to allow easy access. Use the remote control to stop the transfer if needed anytime during raising or lowering.
Page 10
Once the Transfer is clear of the tub, lower the Transfer to the lowest position and push the resident back to their area. Position the Penner Transfer for a transfer back to bed or to another chair. Lock the casters.
“0” the scale may need to be recalibrated. Note: Negative weights are indicated by the weight flashing on and off. Pressing the Penner Patient Care Logo recalls the last weight which was “Held”. Press the “Lb./Kg.” button and hold to convert to Lb. or Kg.
Operating Controls Penner Transfer System Control Unit- Transfer. Can be accessed by carefully removing the protective aluminum cover on the back of the Transfer system. Wall Charging Unit- Mounts on the wall for easy charging of batteries. Control Unit ( bottom view) Pillar Actuator, Battery, and Hand Control plugs in here.
General Precautions and Maintenance of the Penner Transfer System Cleaning (After Every Bath) Clean and disinfect the Transfer after every bath with Penner Cleaner/Disinfectant as follows: Note. Penner Cleaner/Disinfectant is a special non-abrasive cleaning and disinfecting solution that will not harm the tub’s fiberglass surface.
Perform the following safety checks for the Penner Transfer: Seat Belts – Check the condition of the seat belt(s) for signs of excessive wear. Function – Check all functions and brakes on the Penner Transfer, ensure it is operating properly.
Penner Cascade Elite Transfer Parts List INDEX Component Description 380350 BOOT CASTER MOUNTING LG GREY 380405 WASHER 3/8" FLAT SS 1/8" THICK 380360 CASTER REAR TOTAL LOCK POLY 140518 WASHER 3/8 FLAT SS 381452 WASHER LOCK 3/8" SS 381400 SCREW 3/8-16 X 1 1/4" HXHD SS 381475 WASHER FLAT 7/16"...
Penner Cascade Elite Transfer Parts List INDEX Component Description 381112 HAND CONTROL SW/2 COMPLETE 481122 ACTUATOR ELITE TRANSFER 380401 NUT 3/8 X 16 HX SS 18-8 NYLOCK 480365 ADAPTER -ACTUATOR 481150-1 CHAIR COMP BLUE W/O HOLE 481150-2 CHAIR COMP BRWN W/O HOLE...
Penner Cascade Elite End Opening (Transfer Unique Differences) Figure 1 Shown with 48100E Right Hand Base Figure 2 Figure 3 Figure 4 INDEX Component Description 480209 SCREW-3/8-16X1 SH CAP ULT COAT 480195 CHAIR BRACKET - EO ELITE 380350 BOOT CASTER MOUNTING LG GREY...
Page 22
Your Penner Distributor and his personnel are trained to provide in-service instruction and maintenance on your Penner Transfer System . If you have any questions about the operation or maintenance of your System, please contact your Penner Distributor. For your nearest Penner distributor, contact .