Related Manuals for Lanzar WDN2000.1D
Summary of Contents for Lanzar WDN2000.1D
- Page 2 If one of the protection circuits comes on, it will change to red. WDN2000.1D 1.Line Input RCA J acks: These inputs are for signal cables from the source. 2 .Input Level Control: Enables the matching of input levels to the output levels from the source.
-
Page 3: Dual Subwoofers
WDN2000.1D MONO BLOCK AMPLIFIER APPLICATIONS wDN2000.1D 1 ohm STABLE CLASS D MONO BLOCK AMPLIFIER DUAL SUBWOOFERS wDN2000.1D 1 ohm STABLE CLASS D MONO BLOCK AMPLIFIER WRATH... - Page 4 WDN800.2D 2 CHANNEL AMPLIFIER APPLICATIONS wDN800.2D 2 CHANNEL CLASS D FULL RANGE BRIDGEABLE AMPLIFIER wDN800.2D 2 CHANNEL CLASS D FULL RANGE BRIDGEABLE AMPLIFIER WRATH...
- Page 5 Lanzar WRATH SERIES AMIPLIFIER FEATURES MODEL WDN2000.1D WDN800.2D Output Power Rating RMS @ 4 OHM 180W x 1 200W x 2 MAX @ 4 OHM 360W x 1 400W x 2 RMS @ 2 OHM 300W x 1 240W x 2...
- Page 6 WDN2000.1D / WDN800.2D AMPLIFIER APPLICATIONS General: At this point you are ready to get more specific on the settings for your amplifier. Subsonic: This setting acts as a low frequency cut off for your system bass reproduction. The point that you set it at cuts off any frequencies from reproduction beyond this point.
-
Page 7: Troubleshooting
TROUBLESHOOTING Before removing your amplifier, refer to the list below and follow the suggested procedures. Always test the speakers and their wires first. AMPLIFIER WILL NOT POWER UP. Check for good ground connection. Check that remote DC terminal has at least 13.8v DC. Check that there is battery power on the + terminal.