Mercury KOB WCAM301 User Manual

Web digital camera

Advertisement

3.4 Click "Finish" will restart computer
3.5 Then Plug in the KOB WCAM301 WebCam to the USB port
3.6 Windows will automatically detect the new hardware and configure the
device
Copyright Notice
© Copyright 2005, Kobian Group
All rights reserved.
Specifications and features subject to change without notice.
All trademarks and/or registered trademarks are properties of their respective owners.
1.

Introduction

1/4 inch sensor, 6 mm lens, 5 Components 5 Glasses (4G+IR Cut Filter),
60 degree visual angle
380000 pixels dynamic image: CIF (352×288) format, frame rate up to
30 fps; VGA (640×480) format, frame rate up to 15 fps
4 infrared bearing lamps for night function
Auto-illumination in low light condition
Focusing range: 5cm to infinity
Video data format: 8/16/24bit. RGB 24
TWAIN drive supports all kinds of video conference software
Automatic exposure control / automatic white balance
Advanced digital picture control functions, such as color saturation,
contrast, and gamma watch, etc.
2.

System Requirement

Windows 98/ME/2000/XP
USB port in computer
100Mhz Pentium Processor
32MB memory(64MB recommended)
20MB hard disk
2D/3D display card with a minimal 4MRAM supporting and 16 bit color
4x Speed CD-ROM
KOB WCAM301
Web Digital Camera
User's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KOB WCAM301 and is the answer not in the manual?

Questions and answers

Summary of Contents for Mercury KOB WCAM301

  • Page 1: System Requirement

    KOB WCAM301 3.4 Click “Finish” will restart computer Web Digital Camera 3.5 Then Plug in the KOB WCAM301 WebCam to the USB port User’s Manual 3.6 Windows will automatically detect the new hardware and configure the device Introduction 1/4 inch sensor, 6 mm lens, 5 Components 5 Glasses (4G+IR Cut Filter), 60 degree visual angle 380000 pixels dynamic image: CIF (352×288) format, frame rate up to...
  • Page 2 Installing the Driving Program 3.1 Put the driver CD into the CD-ROM and run the D:\WebCam\301\SETUP.EXE. 3.3 Click “Continue Anyway” 3.2 As the window appears as below, click “NEXT” to continue...

Table of Contents