Advertisement
Construction Features
GLASS LINED STORAGE TANK –
duty steel tank protects with double coating of
exclusive Rheemglas
®
action of hot water. Designed for 150 PSI working
pressure. Each tank is supplied with cleanout and
two factory installed magnesium anode rods for
maximum cathodic protection.
WATER CONNECTIONS –
cold inlet are 1-1/4" NPS brass nipples which
prevent excessive turbulence of heated water
and result in optimum tank draw.
HEAVY INSULATION –
of insulation completely surrounds tanks to limit
heat loss and assure high operating efficiency.
STAINLESS STEEL DOOR AND
CONTROL PANEL –
applications.
HEATING ELEMENTS –
are of the screw-in type and are made of top
quality Nichrome
embedded in magnesium oxide
®
sealed in a tinned copper tube to afford corrosion
resistance and long life.
AUTOMATIC TEMPERATURE
CONTROL –
Water temperature is maintained
by an external easily adjustable thermostat
starting with an OFF position and ranging from
100°F to 180°F (38°C to 82°C) that insure instant
power shut off at the selected temperature.
Over temperature protection is provided by an
immersion high temperature limit control, factory
set at 200°F (93°C).
MAGNETIC CONTRACTORS –
equipped with contractors, factory wired for
simplicity of installation and economical
maintenance throughout life of unit.
Heavy
to resist the corrosive
Hot outlet and
An effective blanket
Ideal for food service
Separate elements
All models
240 VOLT CONTROL CIRCUIT –
units are furnished with a 240 volt control circuit.
All controls (thermostats, high temperature limit,
etc.) are operated off of this basic 240 volt control
circuit.
ELECTRICAL CONNECTIONS –
accessible control box with knock-outs on the side
in size selections to match the Canadian Electrical
Code. Sizes range from 1/2" to 2". New terminal
block will accept both copper and aluminum wire.
STANDARD EQUIPMENT ASME T&P
RELIEF VALVE –
This is a double safety valve
that relieves when temperature or pressure
becomes excessive.
STAINLESS STEEL 6" LEGS
SYSTEM SENTINEL
diagnostic panel, utilizing light emitting diodes
(LED) corresponding to the number and location
of each heating element are energized when the
electric elements are operating. An unlit LED
pinpoints the exact location of a non-functioning
element, making element operation diagnosis
simple and positive.
Optional Equipment
ELEMENT FUSING –
above construction features, there is internal
fusing available that protects all elements,
magnetic contractors, thermostats and internal
wiring circuits.
For optional fusing, suffix "F" should be added to
the model number. Ex. EG10CF-12KW
all
Pre-wired,
™
–
An element
In addition to all the
Advertisement
