Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Entes GEM-10
Summary of Contents for Entes GEM-10
- Page 1 GEM-10 GPRS/Modbus Gateway User Manual Rev 1.04 05/2012...
-
Page 2: General Features
ENTES GEM-10 GPRS/Modbus Gateway allows you to connect to your devices which communicate using Modbus protocol via GPRS or Ethernet network. With GEM-10, you can use just one of the GPRS or Ethernet connection options or you can use one of them as backup connection for the other one. -
Page 3: Led Functions
1.2 LED Functions POWER GPRS LINK Green Connected to Ethernet Link Ready GPRS Ready Red (flash) Connecting to Red -Green Signal Strength Green (flash) Ethernet Data Signal level is very good Signal level is good Signal level is moderate Signal level is low Signal level is very low 1.3 Placing the SIM card Place a pen or a screwdriver with a fine tip to the hole next to the SIM card slot and push gently. -
Page 4: Driver Installation
1.4 Driver Installation Since GEM-10 configuration tool communicates using the USB port of your computer, USB drivers in accompanying CD must be installed to your computer. To install the drivers; Connect the device to the USB port of your computer. POWER LED will turn on and your hardware will be automatically detected. - Page 5 Click on “Install this driver software anyway” on the driver compatibility verification window. Your computer will backup your files for System Restore. When the window below is displayed, copying of necessary files to computer is finished. After the installation is finished, you can see your device under Start->Control Panel->Device Manager->Universal Serial Bus controllers.
- Page 6 SIM using your mobile phone. Otherwise, GEM-10 will not connect to Internet. Configuration In order to use the GEM-10 configuration program, you must install the .NET Framework program located in the CD. 2.1 Connection Settings ● TCP Connection Type If you want the device to connect to the IP address in the “Server IP”...
-
Page 7: Ethernet Settings
It indicates that GEM10 will take its IP address for ethernet connection from a DHCP server. ● IP Address It shows the IP address of GEM-10 for ethernet connection. If GEM-10 is assigned an IP address by a DHCP server then this field shows the IP address assigned to GEM-10. -
Page 8: Gprs Settings
To change the password which is used for WEB access, activate the “Change Password” option and enter your new password. Default password is “gem10” and case-sensitive. ** Access to the WEB interface of GEM-10 is only possible by using the ethernet port. 2.3 GPRS Settings ●... - Page 9 GPRS connection. ● Connection Delay This option is valid if GEM-10 is set as Client and it indicates the reconnection attempt interval to the server (monitoring point). ** Please contact your GSM provider for information about your Username, Password and APN Name.
-
Page 10: Firmware Update
It indicates the delay between the response of Modbus device and next transmitted Modbus query 2.5 Firmware Update You can update GEM-10 to latest fimware from this section. To do this; Click on Open button and select the firmware file that you will upload. -
Page 11: Device Info
2.7 Accessing Device Settings via WEB Interface GEM-10 contains an HTTP server which lets the user to change the device settings remotely. This way, the user can change device settings without the need of actually being near the device. In order for this feature to be usable, “WEB Access Active”... - Page 12 After changing any of the settings on each page, click on “Update” button. When all operations on pages are finished, click on “Save Settings” option. Your new settings will be saved on the permanent memory, GEM-10 will restart itself and start its operation again.
Need help?
Do you have a question about the GEM-10 and is the answer not in the manual?
Questions and answers