Weekly Maintenance; Monthly Maintenance; Semiannual Maintenance; Belt Cleaning And Inspection - GE T2100-ST1 Operator's Manual

Preventive Maintenance

Weekly Maintenance

 Vacuum around and under the treadmill. Clean all exposed
surfaces with a vacuum cleaner. Avoid moving the treadmill
from its original position as moving it will compromise the
original belt tracking setting.
 Check running belt tension.
 Observe running belt tracking and correct as required.

Monthly Maintenance

Inspect and clean the belt.

Semiannual Maintenance

 Evaluate the condition of the deck and belt.
 Adjust the belt to assure proper alignment.
 Check the running belt adjustment.
 Check the drive belt tension adjustment.
 Clean and lubricate the treadmill elevation screw.
 Clean the interior of the motor electrical enclosure as needed.

Belt Cleaning and Inspection

1.
2.
3.
4.
5.
6.
40
Turn the treadmill main power switch ON.
Start treadmill at 0.5 mph (0.8 km/h).
With a damp small towel wipe excessive dirt from running belt
keeping the towel in the center of the length of the treadmill.
Avoid getting the towel near the rear roller.
When belt is clean, stop the treadmill.
Inspect the running belt for tears or nicks. If damaged, replace
the belt.
Perform the Running Belt Tracking Adjustment and Belt
Tension Adjustment.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V 2097937-001 Rev E
12 June 2017