Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Drive Medical Bellavita
- Page 1 • Bathlift OPERATING INSTRUCTIONS ENGLISH...
-
Page 2: Table Of Contents
Operating the Bellavita in the bath ........ -
Page 3: Bellavita - Product Description
In these cases, the use of a bathlift is The drive motor and control electronics are com- a great help to re-gain independence and privacy pletely water tight, so you can use the Bellavita in the bathroom. even with the shower on. -
Page 4: For Your Own Safety
Important information mechanism. • Do not use any acetic acid cleaners or deter- • Never use the Bellavita to climb in or out of the gents for cleaning the Bellavita ! bath. Never use it as a stand, lifting device, lad- der, support, or for any similar purposes outside of the bath. -
Page 5: Important Safety Rules
• Clean the battery charger with a dry cloth only. lift or underneath the seat as this may cause • The Bellavita, battery charger and battery, are injury. built in a very robust way, but should not be dropped. -
Page 6: Notes Concerning Electromagnetic Compatibility (Emc)
For your own safety used. In the vicinity of the bathlift, do not operate Notes concerning Electromagnetic any life- preserving or life-supporting devices or Compatibility (EMC) any devices that may cause health hazards for users in the event of malfunction. Such devices This product is compliant with the protection may be subject to electrical interference under requirements set forth in the Council Directive... -
Page 7: First Installation In The Bath
Therefore, the suc- suction caps must be directed outwards – this tion cups at the underside of the Bellavita must ensures better access when the lift has to be be clean and dry. The bath itself must also be removed from the bath. - Page 8 Installation and use 4. Now insert the drive unit with integrated back- 5. Now hold the backrest at the hand grips and rest into the bearing blocks of the seat unit using the other hand tilt it backwards (see (see illustration). illustration) until the drive unit rests against the baseplate.
- Page 9 Installation and use 6. Connect the hand control to the bathlift. To do this, plug the jack socket onto the jack plug until it catches in and the red ring at the jack is unseen. The bathlift is now ready for movement.
-
Page 10: Attaching And Removing The Covers
Installation and use Attaching and removing the covers • To attach the cover, place it correctly on the surface of the backrest and press the fastening The covers can be attached and removed very buttons completely into the holes provided in easily. -
Page 11: Installing The Headrest (Optional)
Installation and use Installing the headrest (optional) Insert the two rods of the headrest into the ope- nings at the top of the backrest plate. The head- rest can be effortlessly adjusted to the desired height. English · 11... -
Page 12: Hand Control
Installation and use Hand control • EMERGENCY-OFF button (red): Depending on the weight of the person bathing, Should an emergency situation occur, all the the capacity of the fully charged battery is for a functions of the bathlift must be brought to a maximum of 6 baths. -
Page 13: Operating The Bellavita In The Bath
Installation and use Operating the Bellavita in the bath 1. Before using your bathlift, make sure that the hand control is connected properly via the plug-type connection on the bathlift. The red ring at the jack is now unseen. Press the ON button (green) on the hand control. -
Page 14: Removing The Lift From The Bath
1. Fold in the side flaps, so that they rest on the The Bellavita switches off automatically after seat surface. approx. 30 minutes. If you wish to switch off the bathlift manually, press red button on the hand 2. - Page 15 Installation and use 3. Make absolutely sure that the lifting rod is always retracted completely. correct incorrect 4. Now the drive unit can be removed from the seat unit in the direction of the arrow (see illu- stration). Note: The drive unit can only be removed at a specific angle.
-
Page 16: Maintenance And Care
Maintenance and care Maintenance of the bathlift Maintenance of seat covers The Bellavita is equipped with maintenance-free The material of the removable covers is very bearings and does not need any lubrication. hygienic due to its smooth surface and antibacte- rial properties. -
Page 17: Maintenance Of The Battery Charger
Maintenance and Care Maintenance of the battery charger The charging unit does not require any mainte- nance. The housing must only be cleaned with mild detergents that are free from solvents, or by means of a damp cloth. Make sure that no liquid enters into the charging unit. -
Page 18: Transport / Mobile Use
Transport / mobile use Please observe the following instructions for 3. If the battery is subjected to low temperatures mobile use: (e.g. storage in a car in the winter), always al- low the battery to warm up to room tempera- 1. -
Page 19: Appendix
Appendix Technical Data Bellavita bathlift Overall length (with backrest in a reclined position) approx. 830 mm (32.7 in) Overall width (seat incl. side flaps) approx. 700 mm (27.6 in) Width of seat approx. 350 mm (13.8 in) Depth of seat approx. - Page 20 Appendix Backrest adjustment 10° – max.50° Sitting height min. 60 mm (2.4 in) Overall length (with inclined backrest) 830 mm (32.7 in) Height of backrest Width of backrest 640 mm (25.2 in) 320 – 360 mm (12.5 – 14.2 in) Depth of seat 420 mm (16.5 in) Overall lenght of seat...
-
Page 21: Troubleshooting
Appendix Troubleshooting Error Possible cause Remedy Lift does not move • Battery is flat – Charge battery • Contacts on hand control – Unplug hand control; wipe are contaminated contacts with a dry cloth and plug hand control in again •... -
Page 22: Warranty
(To qualify for our guarantee, please submit the original invoice, delivery note or date stamp of purchase from your specialist dealer). Damage Our warranty for the Bellavita bathlift will be in due to natural wear or improper handling is ex- accordance with legal stipulations and/or regula- cluded from our guarantee. -
Page 23: Accessories And Spare Parts
Appendix Accessories and spare parts The list below shows the order numbers (part numbers) for original accessories and original spare parts supplied by Drive Medical: Article Order Number • Seat and backrest covers Cover-Set Classic, white 460800252 Cover-Set Classic, blue... -
Page 24: Explanation Of Symbols
Appendix Explanation of symbols Type labels CE-label. This product fulfils all the There are two product labels on the bathlift – on fundamental requirements of the EU the seat unit and drive unit. The product label of Directive concerning Medical Products, the seat is provided underneath the seat;... -
Page 25: Alphabetic Glossary
Alphabetic Glossary Accessories and spare parts ......23 Low temperatures ........... 18 Addresses ............28 Maintenance ........... 16 Appendix ............19 Maintenance of battery charger ...... 17 Backrest ..........3, 8, 9, 15 Maintenance-free bearings ......16 Bath ............5, 13 Malfunction ............ -
Page 26: Notes
Notes 26 · English...
Need help?
Do you have a question about the Bellavita and is the answer not in the manual?
Questions and answers
Can the back be folded down whren stored
Yes, the Drive Medical Bellavita's back can be folded down for storage.
This answer is automatically generated
My suction caps have a second knob. How do I fit them to the base plate
To fit the second knob (tongue) on the suction caps to the base plate of the Drive Medical Bellavita:
1. Ensure the underside of the suction cups and the bathtub are clean and dry.
2. Place the seat unit with suction cups attached to the base plate into the empty bath.
3. Press the tongues of the front suction cups into the provided recesses (front) in the base plate.
4. Make sure the tongues of the rear suction cups are directed outwards for easier removal.
This setup provides firm attachment and better access for removal.
This answer is automatically generated