Advertisement
Simultaneous Washing and Spin Drying
• The machine has two motors designed for washing and spin drying that allows the
user to load, wash and spin dry all at the same time.
• Set the controls for both "wash" and "spin" modes (see "To Wash" and Spin Drying").
CLEARING THE TUB
• First, set the selector knob to "DRAIN" mode.
• Wait until the machine empties completely.
• Then, set the selector knob to "WASH" mode.
• Lastly, unplug the power cord from the outlet.
LAUNDRY GUIDE
Size of
Type of
Water Level
Wash
Fabric
(Volume)
Load
Colored
Full
High
Cotton and
Half &
Low
Linens
Less
Full
Nylon and
High
Half &
P.P
Low
Less
Half &
Delicates
High
Less
INSTALLATION
Electrical Connection
• The unit is designed to function under the recommended power settings mentioned
in the rating label at the back of the washing machine.
• The power cord must be plugged into a grounded 3-pin outlet.
• If the power cord is damaged, it should be replaced by the manufacturer/distributor
or a certified technician.
Connection of Water Inlet Hose
• Attach the water inlet hose to the water inlet (Please refer to the Parts Identification
on page 1). Caution: Please use water BELOW 120°F.
• The drain hose should be placed so that the water can drain down without any
obstruction.
OPERATION INSTRUCTION
Preparing the Wash
• The machine should be placed on a flat surface.
• Separate the laundry into different groups like: white clothes, color clothes, delicate
clothes, lint-free and etc. Wash the laundry according to the washing guide.
• Clothes with worn patches or tears should be mended first. Empty all pockets and
close all fasteners.
Prior to Wash
• Remove the plastic spin mat from the spin tub.
• Check if wash timer knob is set to position "0" and the selector switch is set to "Wash".
• Ensure that drain hose is placed properly to allow draining.
• Insert the power cord into a grounded 3-pin outlet.
To Wash
• Place the wash load and detergent in the wash tub.
• Set the selector switch to "Wash" mode.
• Fill the washing machine with water as recommended in the "Laundry Guide."
• Set the wash timer to the wash period recommended in the laundry guide.
Your machine will now wash for the time selected. When the wash period expires,
set the selector switch to "Drain" position to discharge the water.
Water
Degree of
Wash
Spin
Temperature
Soiling
Period
Period
Wash Cycle
Heavy
Normal
Below 104°F
5-10 mins.
3-5 mins
Light
Normal
4-5 mins.
Below 104°F
2 mins.
Light
2-3 mins.
Normal
Below 104°F
2-3 mins.
1-2 mins.
to Light
PARTS IDENTIFICATION
1. CONTROL PANEL
5. HOUSING
2. WATER INLET
6. SPIN TUB LID
3. PULSATOR
7. SPIN TUB
4. WASH TUB LID
8. POWER CORD
CHIEF TECHNICAL DATA
Rated Wash
Rated Input
Rated Power
Capacity
Power
Source
Model
Wash
Spin
Wash
Spin
Voltage
PUCWM22
3.5KG
1.5KG
250W
120W
110V
WARNING
• When connecting the appliance to the water main, use a new hose,
do not use an old hose.
• For washing machines with ventilation openings at the base, ensure that nothing
is obstructing the openings.
• If the power cord is damaged, it must be replaced by the manufacturer/distributor
or a certified technician.
• This appliance is not intended to be used by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
• Do leave children unattended and play near the appliance.
To Rinse In The Wash Tub
• Set the selector knob to "WASH" mode.
• Turn the water tap on.
• When the rinse water became clear, turn off the water tap.
• Set the selector switch "DRAIN" position to discharge the water.
Spin Drying
• To open the inner safety lid of the spin tub, lift up the outer spin cover and then
lift up the safety lid.
• Transfer the wash load to the spin tub commencing with small articles.
Ensure that the clothes are evenly distributed.
• Place the removable spin mat over the load to be dried and push lightly downward.
(To contain delicate articles within the tub.)
• Set the spin timer to the time recommended in the Laundry Guide.
The spin tub will spin for the time selected and then stop on (at the position "O").
Caution:
Ensure that the spin tub completely stops before reaching in to the wash load.
Do not leave children unattended during this process.
• To remove or reposition clothes during the spin dry cycle, open the spin cover and
inner lids. In this case, the spin tub will automatically stop as a brake is activated
when the spin cover is opened. To restart, close both lids. If required,
reset the spin timer.
• Turn off the spin drying and rearrange the clothes inside the tub if abnormal
vibration is observed during spin drying.
9. PLASTIC SPIN MAT
10.DRAIN HOSE
Energy Efficiency
Packaging
Grade: 5
Dimension
Input Water
Wash Cleaning Rate 0.7
Net/Gross
Pressure
Weight
Area
Consume
Consume
MPA
Frequency
LengthxWidthxDepth
Electricity
Water
(KWh/Cycle/KG)
(L/Cycle/KG)
60 Hz
0.032
36
590x390x675(MM) 11/13KG 0.05~0.3
Advertisement
