Sony SLV-SE310 Quick Start Manual

Video Cassette Recorder
Sony Corporation © 2001
This Quick Start Guide will introduce you to the essential
procedures for using your VCR. Use the Auto Set Up function
to preset all of the receivable channels. Then follow the
additional steps in the Operating Instructions to change the
programme position to your favourite order.
1 Unpacking

2 Inserting the batteries

3 Connecting the VCR

4 Using the Auto Set Up function
5 Tuning your TV to the VCR
Dew caution
If the VCR is brought directly from a cold to a warm location,
moisture may condense inside the VCR and cause damage to the
video head and tape. When you first install the VCR, or when you
move it from a cold to a warm location, wait for about three hours
before operating the VCR.
1
Unpacking
Check that you have received the following items with the VCR:
• Remote commander
• R6 (size AA)
2
Inserting the batteries
Insert two R6 (size AA) batteries by matching the + and – on the
batteries to the diagram inside the battery compartment. Insert
the negative (–) end first, then push in and down until the
positive (+) end clicks into the position.
Quick Start Guide
• Aerial cable
3
Connecting the VCR
i LINE-1
(TV)
4
3
: Signal flow
1
Connect the aerial to AERIAL IN of the VCR.
2
Connect AERIAL OUT to the aerial input of your TV using
the supplied aerial cable.
3
For better picture and sound, connect LINE-1 (TV) to your TV
using a Scart cable if your TV has a Scart (EURO-AV) connector.
4
Connect the mains lead to the mains.
4
Using the Auto Set Up function
AUTO SET UP
You can preset channels.
Hold down AUTO SET UP for three seconds.
When all of the receivable channels are preset, "SET UP"
disappears from the display window. You can rearrange the
programme positions to your favourite order (see "Changing/
disabling programme positions" in the Operating Instructions).
3-065-679-11 (1) GB
1
AERIAL IN
AERIAL
OUT
2
VCR's display window