TP-Link Archer C3150 Quick Installation Manual

Quick Installation Guide
AC3150 Wireless MU-MIMO Gigabit Router
7106505905 REV1.0.2
Connect the Hardware
If your Internet connection is through an Ethernet cable from the wall
instead of through a DSL / Cable / Satellite modem, connect the Ethernet
cable directly to the router's Internet port, then follow steps 5 and 6 to
complete the hardware connection.
Internet
Power adapter
1
Install the antennas.
2
Turn off the modem,
and remove the backup
battery if it has one.
Modem
3
Connect the modem to the
Internet port on your router
with an Ethernet cable.
4
Turn on the modem, and then
wait about 2 minutes for it to
restart.
Router
Power adapter
5
Turn on the router.
6
Verify that the following LEDs are on and solid
before continuing with the configuration.
Power 2.4G 5G Internet
On On
On On
Note: If the 2.4G LED and 5G LED are off, please press the Wi-Fi On/Off
button on the side panel for 2 seconds and check the LEDs again a few
seconds later.
For optimum performance, orient the four antennas
as shown in the drawing below.
30° 30°